Epson RX500 - Stylus Photo Color Inkjet Buradan Başlayın Kılavuzu - Sayfa 4

Yazıcı Aksesuarları Epson RX500 - Stylus Photo Color Inkjet için çevrimiçi göz atın veya pdf Buradan Başlayın Kılavuzu indirin. Epson RX500 - Stylus Photo Color Inkjet 9 sayfaları. Product support bulletin(s)
Ayrıca Epson RX500 - Stylus Photo Color Inkjet için: Kullanıcı El Kitabı (15 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Ürün Bilgi Formu (4 sayfalar), Teknik Özellikler (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Güncelleme (1 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürün Destek Bülteni (1 sayfalar), Eğitim Kılavuzu (4 sayfalar)

Press down on each cartridge until it clicks into

place. Then close the ink cartridge cover.

Caution: Don't force the cartridge cover closed.

If it doesn't close easily, open it and make sure

all the ink cartridges are firmly seated.

Lower the scanner unit.

The RX500 begins charging the ink

delivery system.

Charging takes about 2 minutes. Initial

charge appears on the RX500 screen.

Note: Don't turn the RX500 off while you

see the Initial Charge message or you'll

waste ink.

Load Paper

Insert the paper support into

the two slots on the back of

the RX500.

Connect the short cable leading

from the scanner lid to the round

connector on the back of the

RX500.

Position the connector as shown

here before pushing it in. Don't

force it.

Open the output tray.

Flip the feeder guard forward.

Place a stack of paper in the top

of the RX500, between the edge

guides and beneath their tabs.

Then slide the left edge guide

against the paper, but not

too tightly.

Flip the feeder guard back over

the stack of paper.

Note: If you forget to flip the

feeder guard back, your paper

may jam.