Epson Stylus Pro 7900CTP Kullanıcı Kılavuzu - Sayfa 6
Yazıcı Aksesuarları Epson Stylus Pro 7900CTP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Epson Stylus Pro 7900CTP 12 sayfaları. Large plate accessory kit
Ayrıca Epson Stylus Pro 7900CTP için: Kullanıcı Kılavuzu (28 sayfalar)
Sayfayı Yazdır
| Aligning the Large Plate Guide
6
Using the included hexagonal wrench, adjust the alignment of the plate guide. If distance A is greater than
4.
distance B, tighten the alignment screw; if distance B is greater than distance A, loosen the screw. Half a
rotation of the screw moves the guide approximately 1.0 mm (0.04 inch).
Repeat steps 2 and 3 and, if required, step 4 until the measurements are nearly equal, within 0.5 mm.
5.
Once the plate guide is aligned, you need to confirm the alignment. Use a new plate to print the test
6.
pattern, then print the test pattern again on the same plate. The plate is correctly aligned when the line
thickness at the top and bottom of the printed pattern is no greater than 0.5 mm.
Leading edge
Trailing edge
Correct alignment
Loosen
Tighten
Alignment
screw
Plate
No more than 0.5 mm
difference
Leading edge
Trailing edge
Incorrect alignment
Plate
More than 0.5 mm
difference