Dillon GTS-1000 Operatör El Kitabı - Sayfa 11

Test Ekipmanları Dillon GTS-1000 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Dillon GTS-1000 16 sayfaları.

#1 Operating MODE

The GTS-1000 has two operating modes, marked by an LED on the console. Press to

cycle between:

1. Manual. Once UP or DOWN is depressed, the crosshead moves until any of the

following occurs:

a. Either MOVE key is pressed

b. A limit switch is tripped (in the appropriate direction)

c. The emergency stop button is pressed

2. Auto-reverse. This mode can speed up your repetitive batch testing. It runs at

test speed until it reaches the travel limit and then automatically reverses,

traveling at wide open throttle back to the other limit switch. You can stop the

stand at any time by pressing the UP or DOWN key or Emergency Stop button.

when the sample must be removed before lowering,

The Dillon GTX force gauge offers increased stand control.

In Manual mode, the GTX can stop the stand upon sample break detection.

In Auto-reverse, it can reverse the stand upon sample break detection.

The GTX also interrupts downward travel when gauge capacity is exceeded to reduce

potential for overload.

See accessories for the GTX stand reverse cable.

The overload detection within the GTX is intended as

overloads under slow speeds. The GTX must NOT be

#2 Test SPEED

The GTS-1000 features speed selection keys and a speed display. The

adjust the crosshead speed shown on the LED display. The speed adjustment is slow

initially, but then increases the rate when held down.

Speed may be adjusted while stopped or while moving. Full speed return in auto-

reverse mode is not adjustable.

Take care when adjusting speed up while crosshead

Auto-reverse mode is not suitable for tensile testing

such as ductile metal parts.

a backup approach to help reduce accidental

the primary method to prevent overload.

is moving. Speed may rapidly increase.

CAUTION

WARNING

and

keys