Epson TM-L90 series Üretim Kılavuzu - Sayfa 7

Yazıcı Aksesuarları Epson TM-L90 series için çevrimiçi göz atın veya pdf Üretim Kılavuzu indirin. Epson TM-L90 series 22 sayfaları. Attaching cover on the power switch
Ayrıca Epson TM-L90 series için: Broşür (1 sayfalar), Broşür (2 sayfalar), Ürün Kılavuzu (27 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (8 sayfalar), Bilgi Kılavuzu (5 sayfalar), Teknik Özellikler (4 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (21 sayfalar), Kullanıcı Kılavuzu (21 sayfalar), Buradan başlayın (2 sayfalar), Buradan başlayın (2 sayfalar), Manuel (13 sayfalar), Talimatlar Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), Geliştirme Kılavuzu (34 sayfalar), Manuel (2 sayfalar)

Sayfayı Yazdır

1. Automatic Paper Layout Setup

Confidential

2.4 Paper to Use for High Speed

If any of the following original paper types of receipt roll paper is used, the memory switch for the

customized value setting can be used to set a maximum print speed up to 150 mm/s {5.91

(level 9). The default is 120 mm/s {4.72"/s}:

• TF60KS-E

• PD160R

• TF50KS-E

• P350

• KF50

2.5 Requirements for Black Mark Position for Receipt Paper

When manufacturing receipt paper with black marks, be sure to make paper that meets the

following requirements. (The ESC/POS commands expand the settable range, omitting the

margin settings or the limitation on use (NOTE 2 of Section 3.6).)

The reflecting rates of black mark portions (1) and non black mark portions (2) must meet the

combinations shown in the table below (the reflecting rate is measured using the back of paper,

the non-printing side):

• Black mark portions must be printed on black of paper (non-printing side).

Reflecting rate of black mark portion

(1)

Reflecting rate of the portion where

the black mark does not exist (2)

NOTE: Reflecting rates are measured by the Macbeth PCM-II (Filter D) meter.

Paper without intervals between labels, such as continuous label paper, paper with perforated

lines between labels, and paper with slits between labels, can also be used under the same

requirements.

Preprintable area

Back (non-printing side)

Black Mark Interval Requirement

TITLE

TM-L90

Roll Paper

Manufacturing Guide

17%

16%

15%

90%

85%

80%

(2)

(1)

40 ~ 300

or more

4 ~ 7.5

SHEET

REVISION

14%

13%

75%

70%

Paper feeding

direction

(Units: mm)

NO.

SHEET

/s}

Less