Dimac R40 Kurulum Kılavuzu

Endüstriyel Ekipmanlar Dimac R40 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dimac R40 6 sayfaları.

Sayfayı Yazdır
R30 R40 R50
Model
❖Accessories of Installation
Description of good
Bracket for machine
Electrical cable
Emergency cable
Air hose
Air regulator
Bolts
①for the bracket
②for the machine
③pass line adjusting
Fixture for the air regulator
④Bonding
Mark tube, Terminal
Sticker
Air connector
⑤Apron plate
❖Setting Items
Feed Length, Feed Angle, SPM
Changeable main screen in "Set" state.
Feed length
Feed
Angle
Setting method of table screen
① Power
Turn ON "Power switch"
Numeric value that can be changed item or
number will be blink.
② ← →
Setting items can be changed.
③ + / -
The value can be Changed.
If you need to continue inputting, repeat
②,③.
After setting
④
Set ⇔ Run
Synchronous operation
⑤
Sync Feed
Installation Manual
R30, R40, R50
Exclusive type
P6：8M
8M
8*5：6M
With air filter
4-M14*30
4-M8*25
1-M12*120
2-M6*12
Net　4ml
Assortment
Signal(Feed/Release), Scale for
pass line (on the plate)
1-3/8B, 2-2/8B
Exclusive type
Press rotation speed
Push "Set ⇔ Run" switch, when "Run" lamp is lit, the setting
finishes.
Sync Release
Release Mode
"Release Mode" is not displayed in "Set" state.
To display "Release Mode", push on "Sync
Release" switch in "Set" state.
Setting method of "Release Mode"
① Power
Turn ON "Power switch"
Numeric value that can be changed item or
number will be blink.
② First, push on "Sync Release" switch, keep
it.
③ + / -
The value can be Changed.
When "Sync Release" is turned off, the
display returns the main screen.
Press the both switches of Sync-
Feed, -Release switches, then the
feeder will be able to operate
automatically.
1
DIMAC
⑤
④
②
①
③
Release Mode