Motorola MBP27T/2 Kullanıcı Kılavuzu - Sayfa 30

Bebek Monitörü Motorola MBP27T/2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Motorola MBP27T/2 36 sayfaları. Baby monitor with touchless thermometer
Ayrıca Motorola MBP27T/2 için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (31 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Guidance and manufacturer's declaration – electromagnetic immunity

The MBP27T/MBP27T-2/MBP27T-3/MBP27T-4 is intended for use in the electromagnetic environment

specified below. The customer or the user of the MBP27T/MBP27T-2/MBP27T-3/MBP27T-4 should

assure that it is used in such an environment.

Immunity test

IEC 60601 test

Conducted RF

3 Vrms

IEC 61000-4-6

150 kHz to 80 MHz

Radiated RF

3 V/m

IEC 61000-4-3

80 MHz to 2,5 GHz

NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.

NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by

absorption and reflection from structures, objects and people.

a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones

and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be

predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF

transmitters, an electromagnetic site survey should be considered. If the measured field strength in

the location in which the MBP27T/MBP27T-2/MBP27T-3/MBP27T-4 is used exceeds the applicable

RF compliance level above, the MBP27T/MBP27T-2/MBP27T-3/MBP27T-4 should be observed to

verify normal operation. If abnormal performance is observed, additional measures may be

necessary, such as reorienting or relocating the MBP27T/MBP27T-2/MBP27T-3/MBP27T-4.

b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.

Guidance and manufacturer's declaration – electromagnetic immunity

Compliance

level

Not

applicable

3 V/m

Electromagnetic environment – guidance

Portable and mobile RF communications

equipment should be used no closer to any part

of the MBP27T/MBP27T-2/MBP27T-3/MBP27T-

4, including cables, than the recommended

separation distance calculated from the

equation applicable to the frequency of the

transmitter.

Recommended separation distance

d = 1,2

80 MHz to 800 MHz

d = 2,3

800 MHz to 2,5 GHz

where P is the maximum output power rating of

the transmitter in watts (W) according to the

transmitter manufacturer and d is the

recommended separation distance in metres (m).

Field strengths from fixed RF transmitters, as

determined by an electromagnetic site survey, a

should be less than the compliance level in each

frequency range b.

Interference may occur in the vicinity of

equipment marked with the following symbol:

General Information