Motorola MBP27T/2 Kullanıcı Kılavuzu - Sayfa 21

Bebek Monitörü Motorola MBP27T/2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Motorola MBP27T/2 36 sayfaları. Baby monitor with touchless thermometer
Ayrıca Motorola MBP27T/2 için: Kullanıcı Kılavuzu (36 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (31 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)

Interference

Noise interference on your parent unit

• Your baby and parent units may be too close. Move them farther apart.

• Make sure there is at least 1 to 1.5 meters (3 to 4.5 feet) between the 2 units to

avoid audio feedback.

• lf the baby unit is too far away it may be out of range, so move the baby unit

closer to the parent unit.

• Make sure the baby and parent units are not near other electrical equipment,

such as a television, computer or cordless/mobile telephone.

• Use of other 2.4 GHz products, such as wireless networks (Wi-Fi

Bluetooth

systems, or microwave ovens, may cause interference with this

product, so keep the baby monitor away at least 1.5m from these types of

products, or turn them off if they appear to be causing interference.

• If the signal is weak, try moving the Parent and/or Baby Unit to different

positions in the rooms.

Reasons of Measurement Error

• Dirty probe tip

Please refer to the cleaning process in the manual to make sure the cleanness

of probe tip.

• Unstable human status, such as: hot or cold baths, physical exercise,

smoking and drinking hot or cold drinks ... etc.

Please avoid exercise, bath for 30mins, and keep the forehead clean & dry

before measurement.

• Unstable environment, such as: the vent of air conditioning or fan.

Please stay in door and do not stay in the area where the temperature of skin

would be influenced.

• Wrong measurement area

Users should measure the correct position as Fig. 1 shown on page 13.

• Wrong measurement way

When scanning, the probe should face the Middle of Forehead area & the

measurement distance should be as close as possible.

• Holding the thermometer too long

This may cause the temperature measurement result lower than usual.

Help

routers),