Motorola MBP33S-2 Kullanıcı Kılavuzu - Sayfa 10

Bebek Monitörü Motorola MBP33S-2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Motorola MBP33S-2 28 sayfaları. Digital video baby monitor
Ayrıca Motorola MBP33S-2 için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (31 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)

2.3

Parent Unit Power Supply

IMPORTANT

Installing the rechargeable battery pack and charging it fully before use is

recommended. This will allow the unit to operate on battery in the event of a

power failure.

1. Connect the small plug of the power adapter to the parent unit and the

other end to the electrical outlet. Only use the enclosed power adapter (5V

DC / 600mA) with the slightly smaller DC plug.

2. Press and hold the

the parent unit.

3. Once the baby and parent units are switched on, the display on the parent

unit will show the video captured by the baby unit.

4. If there is no connection or you are out of range, the video display will go

off and the unit will beep every 5 seconds. Move the parent unit closer to

the baby unit until the link is re-established.

5. Press and hold the

finishes scrolling, to turn OFF the parent unit.

NOTE

The battery icon

a beep every 16 seconds. The battery needs to be recharged. The battery pack

takes about 12 hours to charge fully.

When charging

1. During power OFF, when adapter is plugged in, a adapter logo will display

on screen and then a flashing battery logo will display for 45 sec. The Blue

LED at top left corner light up indicates adapter is plugged in.

POWER ON/OFF button for 1 second to turn ON

POWER ON/OFF button, until the progress bar

turns RED to indicate that the battery is low, and it gives

Getting Started