Motorola D501 Manuel - Sayfa 6

Telsiz Telefon Motorola D501 için çevrimiçi göz atın veya pdf Manuel indirin. Motorola D501 44 sayfaları. D5 series
Ayrıca Motorola D501 için: Kullanıcı Kılavuzu (39 sayfalar), Kullanıcı Kılavuzu (38 sayfalar)

Sayfayı Yazdır

1. Getting started

IMPORTANT

Do not place your D5 in the bathroom or other humid areas.

Location

You need to place your D5 base within 2 metres of the mains power and telephone

wall sockets so that the cables will reach. The socket-outlet should be installed near the

equipment and should be easily accessible.

Make sure that it is at least 1 metre away from other electrical appliances to avoid

interference. Your D5 works by sending radio signals between the handset and base. The

strength of the signal depends on where you place the base. Placing it as high as possible

ensures the best signal.

HANDSET RANGE

The unit has a range of up to 300 metres outdoors when there is a clear line of sight

between the base and handset. Any obstruction between the base and handset will

reduce the range significantly. With the base indoors and the handset either indoors or

outdoors, the range will normally be up to 50 metres. Thick concrete and stone walls can

severely affect the range.

SIGNAL STRENGTH

The

icon on your handset indicates that you are within range of the base. When out of

range of the base, the

icon flashes. If you are on a call, you will hear a warning beep.

The line will hang up if the handset moves out of range of the base. Move closer to the

base. The handset will automatically reconnect to the base.

Setting up

IMPORTANT

The base station must be plugged into the mains power at all times. Do not connect the

telephone line cord into the wall socket until the handset is fully charged. Use only the

power adaptor and telephone line cord supplied with the product.

WHICH POWER ADAPTOR?

The power adaptor with a clear connector is for the base unit and the power adaptor with

a red colour connector is for the charger unit (for multi-pack only).

Connecting the base

Getting started