DiMarzio SDS-1 Kurulum Talimatları

Müzik Pedalı DiMarzio SDS-1 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. DiMarzio SDS-1 3 sayfaları.

D i M a r z i o . c o m

Important: Read all of the following instructions before proceeding. If any

questions or problems arise, you may refer them directly to us.

The SDS-1 pickup is a direct replacement pickup for all standard

Stratocasters. However, you will notice that the SDS-1 is somewhat

taller than a standard Strat pickup. On some Stratocasters in which

the pickup holes are shallow, adjustments will be necessary to allow

the pickup to sit properly under the strings. The lead (treble) pickup

should provide no difficulty. The middle and rhythm positions are the

ones which may require attention as described below.

MOUNTING INSTRUCTIONS

If you intend to install the SDS-1 in the rhythm or middle positions,

you must first determine if the pickup will sit safely under the strings,

without any of them touching. If the strings do touch, don't give up;

read on.

First, place the guitar on a flat surface. Loosen the strings enough to

remove the pickguard. Swing the pickguard aside carefully, without

breaking the connections between it and the jack. Now place the

SDS-1 in the guitar, in whichever pickup position on the body you

intend to mount it. This is just for reference: do not connect the

pickup yet. Now, retighten the first and sixth strings. They don't have

to be tuned up to pitch, just tight enough so they are not flopping.

Press down both of these strings at the 21st fret (the highest note on

the guitar). If either of these strings are touching the SDS-1, you

should proceed to one of the following procedures before installing

the pickup.

A. Remove enough wood underneath the pickguard to allow the

SDS-1 to sit underneath the strings.

B. Readjust the neck angle to accomplish the same purpose. Both

procedures accomplish the same thing. (A) lowers the pickup,

while (B) raises the strings.

http://www.dimarzio.com/install/sds_1.html

DiMarzio SDS-1

Page 1 of 3

5/6/2004