Motorola GM1200 Series Kullanıcı Kılavuzu - Sayfa 6
Radyo Motorola GM1200 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Motorola GM1200 Series 19 sayfaları. Gm series professional radio
Ayrıca Motorola GM1200 Series için: Servis Kılavuzu (28 sayfalar)
Sayfayı Yazdır
Fixed and Dynamic Groups
If the shortform dial position selector (16 & 17) is
operated, but no call request is sent, the display will
be held until tone H sounds. The display will then
revert to the IDLE STATE.
Note:
When the shortform dial number is displayed, it
may be edited as described in the Keypad Edit
section (K8 only).
Fixed and Dynamic Groups
A fixed group is a group of users, the address
(number) of which is pre-programmed into your
radio by your dealer.
A dynamic group is a group of users, the address
(number) of which is sent to your radio 'over air' at
any time via the system controller. Therefore at any
time you may become a member of a dynamic
group, able to receive calls and (depending on how
your radio is programmed) send calls to that group.
Incoming calls to fixed and dynamic group numbers
are detailed in Receiving a Call and displayed
under Call Progress - Receiving.
To make an outgoing call to a fixed or dynamic
group address, use the shortform dial position
selector (16 & 17) when the radio is in the IDLE
STATE as detailed in Shortform Dialling.
6
Fixed and Dynamic Groups
English
Dedicated Calls
Hold the dedicated call button (4) down for a preset
period to make a call to a preprogrammed number.
The number will then be displayed and the
conversation can go ahead.
Manual Dialling (K8 only)
To make a call enter the telephone number, the
identity of the radio or group of radios via the keypad
(8), e.g. "210" followed by
210#
Keypad Edit (K8 only)
Before a call is initiated the last digit may be deleted
by pressing the edit button
again to delete the next digit and enter the correct
digit. If the edit button
call, the call will be ended.
or PTT:
#
(7). Press the button
(7) is pressed during a