Motorola GM140 Temel Servis Kılavuzu - Sayfa 26

Radyo Motorola GM140 için çevrimiçi göz atın veya pdf Temel Servis Kılavuzu indirin. Motorola GM140 46 sayfaları. Gm series professional radio uhf (403-470mhz)
Ayrıca Motorola GM140 için: Hizmet Bilgileri (34 sayfalar), Hizmet Bilgileri (32 sayfalar), Hizmet Bilgileri (32 sayfalar)

Motorola GM140 Temel Servis Kılavuzu
3-10
7.3

Radio Chassis and Transceiver Board

1.
Inspect the transceiver board chassis and if required reapply thermal grease to the heatsink
area on the chassis and heat dissipating devices. You may have to remove damaged thermal
pads from the chassis and devices prior to applying the grease.
2.
Insert the transceiver board at an angle (approximately 30°) into the chassis taking care to
slide the antenna connector and accessory connector into their cut-outs in the chassis.
3.
Lower the transceiver board onto the chassis and align the two locating holes in the board
with the locating pins in the chassis.
4.
Secure the cover to the chassis with the six screws previously removed.
5.
Torque the six screws to 1.9 NM (17 in lbs) using the T20 TORX™ driver. Begin with the two
screws located in the middle of the chassis followed by the four outer screws. Since the
screws usually take a set, torque the screws a second time (1.9 NM) in the same order.
6.
Refit the top cover over the assembled radio chassis. Press the cover down until it snaps into
place.
7.4

Control Head Fitting

1.
Align the "0" mark on the flex with the "0" mark on the chassis to the socket on the radio
assembly as shown in Figure 3-2.
2.
Check that the back housing o-ring seal is undamaged and fitted in the groove. Replace the
seal if it is damaged (refer to the exploded view diagrams and parts list).
3.
Fit the back housing to the control head. Ensure that the tags on the back housing align with
the snap catch grooves on the control head. Press the back housing into place until it snaps
into place.
4.
Check that the radio chassis o-ring seal is undamaged and fitted in the groove on the chassis
assembly. Replace the seal if it is damaged.
MAINTENANCE