Motorola GP140 Series Temel Servis Kılavuzu - Sayfa 22
Taşınabilir Radyo Motorola GP140 Series için çevrimiçi göz atın veya pdf Temel Servis Kılavuzu indirin. Motorola GP140 Series 46 sayfaları. Professional radio, power distribution and controller
Ayrıca Motorola GP140 Series için: Kullanıcı Kılavuzu (20 sayfalar), Hizmet Bilgileri (32 sayfalar), Hizmet Bilgileri (30 sayfalar), Hizmet Bilgileri (30 sayfalar)
Sayfayı Yazdır
3-8
7.
The keypad/option board, and the keypad, can be removed without the use of tools.
Figure 3-7 Removing the Keypad Retainer and Other Boards from the Radio Body
NOTE
At this point, the Option Board Installation Procedure should be performed, if necessary.
6.4
Speaker, Microphone, and Universal Connector Flex Disassembly
1.
Turn the screw at the bottom of the dustcover counterclockwise with your Þngers. Lift the dust-
cover out of its pocket.
NOTE
The dustcover must be removed to remove the speaker-microphone assembly ßex circuit.
The speaker is held in place with a two-legged retainer bracket. The bracket legs are
secured by the front cover slots. Be careful not to damage the speaker when removing the
retainer bracket.
2.
Using a screwdriver, push down on the portion of the speaker retainer bracket pointing toward
the bottom of the radio. Then, remove the retainer by slightly pushing it toward the top of the
radio until you slide it past the front cover slot.
3.
Pull the rubber microphone boot from its seated position. Unless you are replacing the micro-
phone, leave it in the boot.
NOTE
The speaker-microphone assembly ßex circuit goes through the front cover wall to the out-
side wall. To replace this assembly, you must peel-off the universal connector escutcheon
label. The existing escutcheon cannot be reassembled; a new part must be used. (See item
number 10 on the exploded view drawing.)
4.
Peel-off the universal connector ßex circuit escutcheon (label).
5.
Pry the ßex circuit (adhesive held) backer board away from the front cover, and remove the
universal connector tail of the speaker-microphone assembly through its opening in the front
cover.
Retainer
1
Display Module
2
Keypad/Option Board
3
Keypad
Radio Body
MAINTENANCE