Motorola radius P110 Kullanım Talimatları Kılavuzu - Sayfa 39
Taşınabilir Radyo Motorola radius P110 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Motorola radius P110 39 sayfaları.
Sayfayı Yazdır
To Transmit
1. Turn the radio on and rotate the CHANNEL
SELECTOR to the desired channel position.
2. Press the MONITOR BUTTON to listen for
activity on your channel.
3. While holding the radio two to three inches
from your mouth, press the PTT button on the
side of the radio and speak. The LED glows
red to indicate transmit status. When finished
transmitting, release the PTT button to
receive.
NOTE
When the PTT button is pressed, the
LED flashes red if there is a low bat-
tery condition. In addition, a double
alert tone is sounded when the PTT
button is released.
Time-Out-Timer (T.O.T)
The T.O.T feature ends a transmission which is
over 60 seconds in length. After time out, a con-
tinuous alert tone sounds until the PTT button is
released.
Voice Activated Transmission (VOX)
To activate the VOX feature, insert a headset in
the accessory connector on a channel pro-
grammed for VOX. You can gain manual control
of the radio by pressing the PTT button at any
time. In order to restart the VOX feature, the
radio must be turned off/on or the channel must
be changed.
Programmable Feature
Enhancements
Channel Scan
The CONTROL BUTTON must be programmed
for Channel Scan for this feature to be func-
tional. To initiate the scan feature, rotate the
CHANNEL SELECTOR to the location with the
scan list programmed to it. The radio will stop
on any active channel and you will be able to
hear the conversation. To locate the last active
scan channel, rotate the CHANNEL SELEC-
TOR and the radio beeps when that channel is
reached. To temporarily eliminate a channel
from the scan list, press the side NUISANCE
DELETE BUTTON while the nuisance channel
is active.
PTT ID (Encode)
Every time the PTT button is pressed, the
radio automatically transmits a unit identifi-
cation (ID) number. While holding the PTT
button, a tone may be heard while the unit
ID number is being sent out.
Call Alert (Decode)
When a Call Alert is received, the monitor
LED flashes yellow and a series of 4 alert
tones sound. A Call Alert "leaves a mes-
sage" for the mobile operator. The monitor
LED continues to flash yellow, and the alert
tones repeat every 10 seconds until the
PTT or any other button is pressed. The
radio then returns to normal operation.
Voice Selective Call (Decode)
When a Voice Selective Call is received, a
one-time 2 beep alert tone sounds, the
monitor LED flashes yellow and the radio
emits a voice message. After the transmis-
sion is completed, the radio returns to nor-
mal operation.