Motorola SBG 1000 Manuel

Modem Motorola SBG 1000 için çevrimiçi göz atın veya pdf Manuel indirin. Motorola SBG 1000 8 sayfaları. Connecting to the internet

Connecting to the Internet

Connecting to Time Warner Cable | LAN Hardware Requirements

Computer Requirements | LAN Configuration Requirements |

Connecting the SBG1000 to the Cable System | Cabling the

Ethernet or HPNA LAN | Obtaining an IP Address in Windows 98,

Windows 98 SE, or Windows Me | Obtaining an IP address in

Windows 2000 or Windows XP | Obtaining an IP address on

Macintosh | Connecting a PC to the USB Port | Setting Up the

Wireless LAN | Installing the Optional External Diversity Antenna

| Starting the Setup Program

This section describes how to set up the SBG 1000 Gateway on the LAN.

Before connecting the gateway to the Internet the following must be prepared:

1. Determine the type of connection best suited to the SBG1000 – Ethernet,

HPNA, Wireless, and USB.

2. A computer properly connected to the gateway as explained below.

3. Active Data Over Cable Internet service provided by cable modem

account.

4. The Road Runner (ISP) configuration information for the cable modem

account.

5. For Ethernet connection, Ethernet cables and Network Interface Card

(NIC's) with the accompanying software.

6. For HPNA, telephone jumper cables, HPNA interface cards, and the

accompanying software.

7. For wireless connections, wireless adapters and the installation software

for the adapters.

8. For USB, a USB cable and the Motorola SBG1000 Wireless Gateway &

Cable Modem CD-ROM, which contains the software for a USB

installation.

Connecting to Time Warner Cable

To connect to Time Warner Cable, complete the following:

1. Using a coaxial cable provided by Time Warner Cable, connect the coaxial

cable jack on the wall to the cable connector on the gateway.