Epson 2450 - Perfection Photo Scanner Ürün Bilgileri - Sayfa 3

Yazılım Epson 2450 - Perfection Photo Scanner için çevrimiçi göz atın veya pdf Ürün Bilgileri indirin. Epson 2450 - Perfection Photo Scanner 5 sayfaları. Product support bulletin(s)
Ayrıca Epson 2450 - Perfection Photo Scanner için: Kullanıcı Kılavuzu (7 sayfalar), Ürün Destek Bülteni (34 sayfalar), Buradan başlayın (2 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (11 sayfalar), Ürün Destek Bülteni (40 sayfalar), Ürün Destek Bülteni (17 sayfalar), Uygunluk Beyanı (2 sayfalar), Ürün Destek Bülteni (14 sayfalar), Ürün Destek Bülteni (18 sayfalar), Ürün Destek Bülteni (36 sayfalar)

Scanning Transparencies and Film

Before scanning transparent documents, you need to remove

the scanner's reflective document mat; this exposes the scanner's

transparency unit (light source), which is built into the lid.

If you're scanning slides or film strips, you'll also need to use

one of the film holders.

To use the transparency unit, remove the reflective document

mat by grasping the top of the mat and sliding it up gently, as

shown.

remove mat

by sliding it up

Make sure the cable for the tranparency unit is plugged into the

round connector. If not, turn off the scanner, then connect the

cable as shown.

Using Film Holders

Film has two sides, a shiny base side and a dull emulsion side.

The base side of the film has the film maker's name and film ID

numbers printed on it. Always place the shiny base side down.

To scan 35-mm film strips, 4 × 5-inch film, or 120/220 (6 × 9-

cm) film, place the film in the correct holder, as shown:

transparency unit

Place the holder with the film onto the scanner. Make sure the

white triangle on the holder points to the upper-right corner of

the scanner.

9/01

EPSON Perfection 2450 PHOTO

35-mm strips

4 × 5-inch film

EPSON Perfection 2450 PHOTO - 3

120/220 (6 × 9-cm)

film