Epson ES-800C Ürün Destek Bülteni - Sayfa 4

Yazılım Epson ES-800C için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson ES-800C 5 sayfaları. Product support bulletin(s)
Ayrıca Epson ES-800C için: Kullanıcı Kılavuzu (5 sayfalar), Tamamlayıcı Kılavuz (15 sayfalar), Manuel (11 sayfalar), Ürün Destek Bülteni (8 sayfalar)

Sayfayı Yazdır
Epson ES-800C Ürün Destek Bülteni
NOTE:
This document assumes that you are using an Adaptec card. The AHA1510 and
AHA1540C were tested when creating this document.
Once you have verified that the above lines are in the CONFIG.SYS, shut down
OS/2 and reboot.
NOTE:
If the SCSI card does not find any devices on the SCSI chain, the AHAxxxx.ADD
driver will not load thus causing VASPI.SYS not to load. If this occurs, double
check your card's configuration and the SCSI cabling.
Epson TWAIN ~1.0~
Follow the steps below to enable Epson TWAIN ~1.0~:
1.
From the OS/2 desktop, double click on the OS/2 SYSTEM folder
2.
Double click on the COMMAND PROMPTS folder
3.
Double click on the Win-OS/2 icon.
4.
Once Windows is loaded, follow the TWAIN installation procedure. When the
installation program asks if you wish to make changes to the CONFIG.SYS or
the CONFlG.ADD, select CONFIG.ADD.
5.
Once the installation has completed, exit Windows.
6.
If the COMMAND PROMPTS folder is not open, follow steps 1 and 2.
7.
Move the mouse to the WIN-OS/2 FULL SCREEN icon. Click on the right
mouse button.
8.
Select SETTINGS from the pop-up menu.
9.
Once the SETTINGS notebook has opened, click on SESSION.
10.
Click on the WIN-OS2 SETTINGS.
11.
Click on OTHER DOS SETTINGS.
12.
Click on OK.
13.
Highlight DOS-DEVICE.
14.
In the window to the right, add the EPSN.SYS driver. X represents the
appropriate SCSI ID of the scanner.
The device line would be entered in the following manner.
C:\EPSN.SYS 3 /Sx /i79
PSB No: P-0103A
Page: 3 of 4