Epson FX-1180 - Impact Printer Ürün Bilgileri - Sayfa 9

Yazılım Epson FX-1180 - Impact Printer için çevrimiçi göz atın veya pdf Ürün Bilgileri indirin. Epson FX-1180 - Impact Printer 17 sayfaları. Epson serial impact dot matrix printers
Ayrıca Epson FX-1180 - Impact Printer için: Kurulum Kılavuzu (33 sayfalar), Broşür ve Teknik Özellikler (24 sayfalar), Hızlı Referans Kılavuzu (16 sayfalar), Manuel (11 sayfalar), Şartname (2 sayfalar), Manuel (18 sayfalar), Teknik Özellikler (2 sayfalar), Sınırlı Garanti (1 sayfalar), Referans Kılavuzu (34 sayfalar), Hızlı Kılavuz (33 sayfalar)

Sayfayı Yazdır

Epson FX-1180 - Impact Printer Ürün Bilgileri

Paper Thickness Lever Positions

The paper thickness lever is located under the printer cover.

You need to set the paper thickness lever for the type of paper

you are using, as shown in the table below.

Paper Type

Ordinary paper (single sheets or continuous paper)

Carbonless multi-part forms with:

2 parts (original + 1 copy)

3 parts (original + 2 copies)

4 parts (original + 3 copies)

5 parts (original + 4 copies)

6 parts (original + 5 copies)

Thin paper

Continuous paper with labels

Envelopes

Paper Handling

Loading Continuous Paper Onto a Push

Tractor

Front push tractor

Load paper printable side up.

Rear push tractor

1. If you are using the front push tractor, remove the front

Lever Position

2. Open both sprocket covers.

3. Fit the first four holes of the paper over the sprocket pins (as

–1 or 0

2 to 6

4. If you are using the front push tractor, reattach the front

5. Make sure the paper release lever is in the correct position.

6. Make sure that the paper guide is lying flat on the printer

Removing the Printed Document from a

Push Tractor

1. Make sure the

11/98

EPSON FX-880/FX-1180

Load paper printable side down.

cover.

If you are using the rear push tractor, remove the paper

guide.

shown above). Then close the sprocket covers.

Note:

Make sure the left and right sprockets are positioned properly

for your paper's width. If they are too far apart or there is any

slack in the paper, you need to move the sprockets.

cover.

If you are using the rear push tractor, reattach the paper

guide.

and the continuous paper support is in the upright position.

Tear Off/Bin

to press the

button.) When the

Tear Off/Bin

light is flashing, your paper is in the tear-off

Tear Off/Bin

position.

light is flashing. (You may need

EPSON FX-880/FX-1180

- 9