Dimplex 6910290100 Kullanıcı El Kitabı - Sayfa 13
Kapalı Şömine Dimplex 6910290100 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dimplex 6910290100 16 sayfaları.
Sayfayı Yazdır
Troubleshooting
PROBLEM
POSSIBLE CAUSE
No power,
The unit does not have
logs do not
power.
glow.
E1 displayed
The overheat
on control
protection device has
panel.
been engaged.
E2 displayed
The ambient
on control
temperature sensor is
panel.
broken or not working
correctly.
E3 displayed
Child lock function
on control
activate.
panel.
Fan motor
Normal operation
continues
to blow
after unit is
powered
off.
Power cord
Normal operation.
gets warm to
the touch.
SOLUTION
Check that unit is plugged into a
standard 120 volt outlet. Then make
sure power is set at "ON" position.
Unplug unit, wait 5-10 minutes, then
the sensor will reset itself. Plug the unit
back in and turn on the heater. If the
problem persists, call customer service.
Unplug unit, wait 5-10 minutes, then
the sensor will reset itself. Plug the unit
back in and turn on the heater. If the
problem persists, call customer service.
To inactivate the Child Lock function,
holding the POWER button for 10
seconds.
This is a standard feature; the blower
runs for an additional 20 seconds to
ensure heat will not be trapped inside
the unit.
This is normal for a heater appliance
as it requires more current to operate.
Check the connections of the appliance
cord and the outlet. Make sure the plug
fits tightly into the outlet. During use,
check the plug and outlet frequently to
determine if it is HOT; if so, discontinue
use of the appliance and consult with a
qualified electrician to check or change
the overheating outlet(s).
13