Epson PowerLite 475W Hızlı Kurulum Kılavuzu - Sayfa 3
Yazılım Epson PowerLite 475W için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Epson PowerLite 475W 4 sayfaları. Maintenance
Ayrıca Epson PowerLite 475W için: Kullanım Kılavuzu (50 sayfalar), Uygunluk Beyanı (4 sayfalar), Hızlı Kurulum Kılavuzu (4 sayfalar), Teknik Özellikler (6 sayfalar), Kurulum El Kitabı (4 sayfalar)
Sayfayı Yazdır
4
Replace the cable cover and tighten the screws.
5
Plug in and turn on the projector.
6
To configure your projector for your wireless network, do one of
the following:
•
If you're using the optional Quick Wireless Connection USB key
(Windows only), insert it into the projector's USB TypeA port, wait
for the displayed message, remove the key, and connect it to a USB
port on your computer. Follow the on-screen instructions to install
the driver, then run your presentation. For details, see the online
User's Guide.
•
If you're not using the key, continue with these steps.
7
Press the Menu button on the remote control, select the Network
menu, and press
.
8
Choose Network Configuration and press
9
Select the Basic menu and press
10
Select the Projector Name setting, press
16 characters long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press
them.
Note: See the online User's Guide for information on adding passwords.
11
Select the Wireless LAN menu and press
12
Select the Connection Mode setting, press
these options:
•
Quick to connect the projector to one computer on the network
•
Advanced to connect the projector to multiple computers on
the network
13
If you selected Quick connection mode, select the Channel setting for
your wireless network and turn on the SSID Auto Setting setting.
.
.
, and enter a name (up to
to select
.
, and choose one of
14
Select the type of wireless network you are using as the Wireless LAN
Sys. setting.
15
If you selected Advanced connection mode, enter your network SSID (up
to 32 characters) as the SSID setting.
16
If your network assigns addresses automatically, select IP Settings and
turn on the DHCP setting. If not, turn off the DHCP setting and enter
the projector's IP Address, Subnet Mask, and Gateway Address,
as needed.
17
To prevent the SSID and IP address from appearing on the network
standby screen, set the SSID Display and/or IP Address Display settings
to Off.
18
When you are finished, select Complete and press
again to save your settings.
19
Press the Menu button to exit the menu system.
20
See "Install network software" for additional instructions.
Project over a wired
network
Follow the steps here to configure your projector for your wired network using
the projector's menu system.
1
Plug in and turn on the projector.
2
Press the Menu button on the remote control, select the Network menu,
and press
.
3
Select Network Configuration and press
4
Select the Basic menu and press
5
Select the Projector Name setting, press
16 characters long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press
them.
Note: See the online User's Guide for information on adding passwords.
, then press
.
.
, and enter a name (up to
to select