Epson PowerLite 82c Şartname Sayfası - Sayfa 12

Yazılım Epson PowerLite 82c için çevrimiçi göz atın veya pdf Şartname Sayfası indirin. Epson PowerLite 82c 15 sayfaları. Projector
Ayrıca Epson PowerLite 82c için: Kullanıcı Kılavuzu (42 sayfalar), Kullanım Kılavuzu (47 sayfalar), Parça Listesi (1 sayfalar), Hızlı Kurulum Kılavuzu (7 sayfalar), Kurulum Kılavuzu (19 sayfalar), Ürün Destek Bülteni (25 sayfalar), Ürün Destek Bülteni (8 sayfalar), Ürün Destek Bülteni (22 sayfalar), Ürün Destek Bülteni (28 sayfalar), Uygunluk Beyanı (4 sayfalar), Ürün Destek Bülteni (41 sayfalar), Ürün Destek Bülteni (15 sayfalar), Ürün Destek Bülteni (22 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (2 sayfalar)

Sayfayı Yazdır

Epson PowerLite 62c/82c Projector

2. Turn the projector upside-down and clean the air filter and

air intake vent. Epson recommends using a small vacuum

cleaner designed for computers and other office equipment.

If you don't have one, gently clean them using a very soft

brush (such as an artist's brush).

If dirt is difficult to remove or the filter is torn, replace it.

The air filter set (part number

filters. See page 14 for ordering information.

3. If you need to replace the filter, slide it off, as shown.

4. Align the new filter carefully and slide it in until it clicks

into place.

Epson PowerLite 62c/82c Projector

Air vent

Air filter

) contains two

V13H134A08

Replacing the Lamp

The projection lamp typically lasts for about 2000 hours of use

(in high brightness mode) or 3000 hours (in low brightness

mode). It is time to replace the lamp when:

❏ The projected image gets darker or starts to deteriorate.

❏ The

light is flashing orange.

Lamp

❏ The message

Replace the Lamp

when the lamp comes on. To maintain projector brightness

and image quality, replace the lamp as soon as possible.

See page 14 for ordering information and request part number

V13H010L34

Note:

You can check to see how many hours the lamp has been used using

the Info menu. See your on-screen User's Guide for instructions.

Follow these steps to replace the lamp:

1. Press the P

Power

When you hear the projector beep twice, unplug the power

cord.

2. If the projector has been on, allow it to cool down for at

least an hour (or until the lamp is cool).

Warning:

Let the lamp cool before replacing it. If the lamp breaks, handle

the shards carefully to avoid injury.

3. Use the screwdriver included with the replacement lamp to

loosen the screw holding the lamp cover on top of the

projector. Then slide the cover out and lift it off.

4. Use the screwdriver to loosen the two screws holding the

lamp in place. (You can't remove the screws.)

9/05

appears on the screen

button twice to turn off the projector.

Loosen these

screws