Toshiba e-Studio 1207 Hızlı Başlangıç Kılavuzu - Sayfa 18
Hepsi Bir Arada Yazıcı Toshiba e-Studio 1207 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Toshiba e-Studio 1207 37 sayfaları. Digital multifunctional system
Sayfayı Yazdır
MANUAL FINISHING
This function allows you to set for finish on copied or printed pages.
You can select the manual finishing mode if the inserter is installed.
When the finisher, saddle finisher, punch module, or folding unit is installed, finishing operations, such as stapling, punching or folding, can be performed.
Basic operations
1
Place the original
Adjust the inserter tray guide to the pa-
per size, and load paper.
(Special media such as transparency
film and tab paper cannot be used.)
Paper Loading and Output Settings
Plain
Checking and changing
Upper
8 x11
1
Tray
2
the output tray
Plain
Lower
8 x11
1
Tray
2
You can check the type and size of paper loaded.
As needed, the paper type and size can be specified for each of the
upper and lower trays.
If you wish to change the paper sizes or types, select [System
Settings] > [Paper Tray Settings] > [Inserter].
Plain
Check the paper type and size
8
x11
1
2
Upper
Selects the upper tray as paper tray
Tray
Lower
Selects the lower tray as paper tray
Tray
2
Switch to the manual finishing
mode
Changing modes from the Home
Screen
Changing modes from the screen
for each mode
Middle
Checking and changing
tray
Offset
Tray
The output tray is automatically selected based on the output
function you set. If Z-Fold, Half Fold, or Punch is selected, however,
you can select the middle or offset tray for the output tray.
If you have changed the output tray, the output function may be
deselected depending on the original output settings.
Middle
Selects the middle tray as the output tray
tray
Offset
Selects the offset tray as the output tray
Tray
3
Finishing method settings
1 Select the appropriate finishing method
2 Change the paper tray or output tray as
required
the output tray
4
Start
Orientation of placed original
For stapling or punching on the desired position,
place the paper as shown in the following:
• For staple function, place the paper face up and
align text with the direction of the touch panel
display. (For the saddle stitch function, place the
paper so that middle surface faces up.
• When using punch or folding function, place the pa-
per face up, and align text horizontally and upward
with the scan (right) direction.
18