Toshiba E-STUDIO 2520AC Bilgi - Sayfa 20
Hepsi Bir Arada Yazıcı Toshiba E-STUDIO 2520AC için çevrimiçi göz atın veya pdf Bilgi indirin. Toshiba E-STUDIO 2520AC 44 sayfaları. Multifunctional digital color systems / multifunctional digital systems
Sayfayı Yazdır
1.Information About Equipment
When turning the equipment back on after turning it off, wait for approximately 30 seconds.
Saving energy when not in use – energy saving modes –
The following modes are available; Automatic Energy Save mode, Sleep mode, and Super Sleep mode. The table
below shows the procedures to switch modes manually and conditions under which it enters into or recovers from
each mode.
Energy saving
modes
Automatic Energy
Save mode
Sleep mode
Super Sleep mode
*1 The default value is 1 minute.
*2 The [ENERGY SAVER] button on the control panel.
*3 Any of IPX and other protocols. When the IPsec function is enabled, the equipment enters Sleep mode.
For details, see the reference below:
TopAccess - [Administration] - [Setup] Item List - General settings - Setting up Energy Save
*4 Depending on the network environment, the time for switching to Super Sleep mode may take more than 10 minutes even if it is set to 10
minutes or less.
*5 The motion sensor can be used only for some models. For details, see the reference below:
P.14 "Motion Sensor"
To change the time for entering each mode, see the reference below:
User Functions - SETTING ITEMS (Admin) - General - Setting the energy saver modes
20 Turning On/Off
Procedure to
Conditions to enter
switch modes
into the mode
When a specified
*1
period of time
has passed since
the last use of the
equipment.
When a specified
When a particular
*1
period of time
protocol
has passed since
the last use of the
equipment or
when you press
the [ENERGY
*2
SAVER] button
.
When a condition
When particular
to shift into the
protocol and setting
super sleep mode
are disabled.
*1 *4
is satisfied
.
Status of equipment
—
A message is displayed
to indicate the energy
saving status.
The touch panel
*3
display turns off. The
is enabled.
[ENERGY SAVER]
button turns green.
The touch panel
*3
display turns off. The
[ENERGY SAVER]
button turns green.
Conditions to
recover from the
mode
When you press a
button on the control
panel. When print or
fax data are received.
When the ADF or
original cover is open.
When an original is
detected by the ADF.
Same as the Automatic
Energy Save mode.
When you press the
[ENERGY SAVER]
button on the control
panel.
When print or fax data
are received through a
wired LAN.
When the time set for
Scheduled Print has
come.
When the motion
*5
sensor
detects the
approaching of a
person.