Epson Stylus Pro 7600 Ambalajdan Çıkarma ve Kurulum Kılavuzu - Sayfa 10
Yazılım Epson Stylus Pro 7600 için çevrimiçi göz atın veya pdf Ambalajdan Çıkarma ve Kurulum Kılavuzu indirin. Epson Stylus Pro 7600 24 sayfaları. W 24-inch-wide and 44-inch-wide photographic
printers with new seven-color ultrachrome ink system
Ayrıca Epson Stylus Pro 7600 için: Manuel (5 sayfalar), Hızlı Referans Kılavuzu (11 sayfalar)
Sayfayı Yazdır
6. Hook the both ends of the center shafts (U) on
the upper basket hooks.
U
7. Hold the front side shafts (V) and turn it one
revolution as shown below.
8. Slide out the lower basket hooks to their full
length, then attach the L shape ends to the joint
sockets (W) on the front side.
9. Slide the upper and lower basket hooks back.
10. Hook the basket rings in the direction shown
below to take up the slack.
8
V
W
11. As shown in the figure, hook the paper feed
support film on the intermediate shaft of the
paper basket, so that it hangs along the inner
surface of the basket.
Note:
Set five paper feed support films at even intervals
in the order shown in the figure.
Unpacking and Assembling
Stylus Pro 7600
Choosing a Place for the Printer
Leave adequate room for easy operation,
maintenance, and ventilation.
Leave at least 15 cm between the back of the
printer and the wall.
Place the printer on a desk. If you can not place
the printer on a desk, you will need the
optional Stand. If you place your printer on a
desk, follow the guidelines listed below.
Choose a desk that can hold the printer
weight (about 43.5 kg) and has a height of
600-800 mm from the floor.
Make sure the surface is flat and stable.