Epson Stylus Pro 9600 Photographic Dye Ink Manuel Güncelleme - Sayfa 2

Yazılım Epson Stylus Pro 9600 Photographic Dye Ink için çevrimiçi göz atın veya pdf Manuel Güncelleme indirin. Epson Stylus Pro 9600 Photographic Dye Ink 4 sayfaları. Large format digital colour printing
Ayrıca Epson Stylus Pro 9600 Photographic Dye Ink için: Broşür ve Teknik Özellikler (24 sayfalar), Ambalajdan Çıkarma ve Kurulum Kılavuzu (24 sayfalar), Bilgi Kılavuzu (16 sayfalar), Parça Listesi (21 sayfalar), Hızlı Kurulum Kılavuzu (34 sayfalar), Ürün Bilgileri (15 sayfalar), Hızlı Referans Kılavuzu (11 sayfalar), Broşür ve Teknik Özellikler (8 sayfalar), Broşür ve Teknik Özellikler (6 sayfalar), Broşür ve Teknik Özellikler (16 sayfalar), Ürün Referans Kılavuzu (28 sayfalar), Teknik Özellikler (4 sayfalar)

5. Stylus Pro 7600 users should remove the polystyrene foam stoppers under the printer.

Mounting the printer on the base unit (Stylus Pro 9600 only)

The figure in step 5 on page 6 has been changed as shown below. Fasten the bottom of the printer and base

unit with wing nuts, spring washers, and washers.

washer

spring washer

wing nut

Removing the protective materials

Remove the tape from the maintenance tank on the right side of the printer.

Attaching the paper basket (Stylus Pro 9600 only)

Step 4 on page 7 has been changed as described below.

After passing the rear shaft under the horizontal strut, rotate the rear paper basket joints to enfold the bar that

is not attached to the fabric, as shown below. Then follow the instructions in the Unpacking and Setup Guide.

Assembling the Stand (Stylus Pro 7600 only)

The figure in step 3 on page 11 has been changed as shown below. Insert the bottom horizontal strut into the

right and left bases as shown. Use hex wrench to fasten the strut with collars and strut bolts.