Philips AS9300 Manuel - Sayfa 3

Stereo sistemi Philips AS9300 için çevrimiçi göz atın veya pdf Manuel indirin. Philips AS9300 18 sayfaları. Midisystems
Ayrıca Philips AS9300 için: Kullanıcı Kılavuzu (15 sayfalar)

Sayfayı Yazdır

CONTROLS

Fig. 2

G@) POWER

switch, for switching the entire unit

on/off.

(@) Graphic equalizer tone controls.

@) Dial pointer with on/off indicator.

G) Dust cover for record player.

G) (NOT ON ALL VERSIONS)

LW/MW wave range

selector (some versions SW/MW).

©) AM/FM

wave

range

selector

(some

versions

MW/FM).

@ STEREO/MONO selector.

FREQUENCY

TUNING

control, for tuning into

radio stations.

@) FM STEREO

indicator: lights up when an FM

broadcast in stereo is received and selector @is

in the STEREO position.

(a) VOLUME control.

(@) DYNAMIC BASS BOOST button with indicator.

(2 CD.TV selector with indicator.

(3) PHONO selector with indicator.

(3) Cassette holder deck IL.

¢3) PHONES socket (6.3 mm) for connecting stereo

headphones

(impedance

8-1000 ohms).

The

loudspeakers

are

automatically

switched

off

when using headphones.

PAUSE button: for stopping the tape transport in

deck I momentarily.

WIND button for deck II: for fast forwarding the

tape.

(2 REW button for deck I: for fast rewinding the

tape.

PLAY button for deck II for starting playback.

STOP/EJECT button for deck I.

@i) PAUSE button: for stopping the tape transport in

deck I momentarily.

@2 WIND button for deck I: for fast forwarding the

tape.

@) REW button for deck I: for fast rewinding the tape.

@3) PLAY button for deck I: for starting playback.

@) RECORD button: to make a tape recording.

@) STOP/EJECT button for deck I.

@) Cassette holder deck I.

@) TUNER selector with indicator.

@) TAPE selector with indicator.

62) HIGH SPEED DUBBING selector with indicator,

for selection of normal or high tape speed when

dubbing.

Record player, Fig. 3 (not on all versions)

Z\ Adapter for 45 rom. records.

ZX Transit screws.

AX Cue lever, for lifting and lowering the tone arm.

Z\ Speed selector 33-45, for selecting the speed.

AX Fixing clip for the tone arm.

OPERATION

SWITCHING ON AND OFF

@ Use POWER switch G) to switch on the unit. The

on/off indicator @) will light up.

@ To switch off, press

POWER

switch @) again.

Indicator @) will fade.

Note: To prevent damage first switch off the record

player or tape decks.

— The record player: by moving lever A\ to the ¥

position and then moving the tone arm outwards.

When the arm reaches the support, the turntable will

stop.

— The tape decks: by pressing the STOP/EJECT

button once.

AMPLIFIER

@ Turn the volume control

to. minimum

(fully

anti-clockwise).

e@ Press one of the selector buttons CD.TV @,

PHONO (3), TUNER @e), or TAPE @). The appropriate

indicator will light up.

@ Turn the volume control @ to the desired level.

@ Adjust

the

tone

using

the

graphic

equalizer

controls @). Press the DYNAMIC

BASS

BOOST

button (1) for additional

amplification of the bass

reproduction.

TUNER

@ Select tuner mode (radio) with TUNER button @é).

@ Select the desired tuning range: MW or LW (for

some versions SW) using selector () (with selector

selector () set to FM.

@ Tune

to the desired

station with FREQUENCY

TUNING knob (8).

@ if there is interference when receiving FM stereo

broadcasts, put STEREO/MONO

button @) in the

MONO

position.

STEREO

indicator @) will then

extinguish.

Note:

In the

MONO

position

any

stereo

noise

resulting from weak stereo reception will disappear.

Under normal circumstances, leave this button in the

STEREO position.

RECORD

PLAYER (not on all versions)

@ Select the phono

mode

with PHONO

Selector

button (9.

e@ Place a record on the turntable. For records witha

large centre hole, use the adapter A\.

@ Remove the stylus protector by pulling it forwards.

e Use selector A\ to select the appropriate speed.