Philips AZ 2407 Kullanıcı El Kitabı - Sayfa 18

Stereo sistemi Philips AZ 2407 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Philips AZ 2407 21 sayfaları. Portable micro system
Ayrıca Philips AZ 2407 için: Kullanıcı El Kitabı (20 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı El Kitabı (20 sayfalar), (Danca) Kullanım Kılavuzu (18 sayfalar)

Sayfayı Yazdır

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service

center.

WARNING: Under no circumstances should you try to repair the set yourself, as this would

invalidate the warranty.

PROBLEM_

POSSIBLE CAUSE

• REMEDY

No sound/power_

VOLUME is not adjusted.

• Adjust the VOLUME.

Headphones are connected.

• Disconnect headphones.

Batteries are exhausted.

• Insert fresh batteries.

Batteries are incorrectly inserted.

• Insert the batteries correctly.

Pwer cord is not securely connected.

• Connect the power cord properly.

- Batteries loaded but power cord still plugged

in and connected.

•

Pull out the power cord from the MAINS

outlet and the set.

Reversed left and right sound/no sound

from one speaker_

Speakers incorrectly connected

• Connect properly: L to left, R to right

Poor bass sound_

Speakers not in phase.

• Connect speaker poles correctly,

pole (red

marked wire) to

-'pole (black/unmarked

wire) to.

CD playback does not work_

CD is badly scratched or dirty.

• Replace or clean the CD, see Maintenance.

Laser lens steamed up

• Wait until lens has acclimatized

The CD skips tracks_

CD is damaged or dirty.

• Replace or clean the CD.

PBOGRAM/SHUFFLE is active.

• Switch off the PROGRAM/SHUFFLE function.

Poor cassette sound quality_

Dust and dirt on the heads, capstan or

pressure roller.

• Clean the heads etc., see Maintenance.

Use of incompatible cassette types (METAL

or CHROME).

• Only use NORMAL (IECI) for recording.

Recording does not work_

Cassette tab(s) may be broken out.

• Apply a piece of adhesive tape over the

missing tab space.

Remote control does not function properly

Batteries are exhausted.

• Insert new batteries.

Batteries are incorrectly inserted.

• Insert batteries correctly.

Distance or angle between the set is too

large.

• Reduce the distance or angle.

The type plate is located on the base of the set.