Philips DCM2068 Kullanıcı Kılavuzu - Sayfa 8
Stereo sistemi Philips DCM2068 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Philips DCM2068 18 sayfaları. Micro system
Ayrıca Philips DCM2068 için: Kısa Kullanım Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (18 sayfalar)
Sayfayı Yazdır
Store FM radio stations
automatically
When you connect AC power and no FM
stations are stored, the system prompts you to
search and store all the available FM stations.
1
Connect the system to the power supply.
» [AUTO INSTALL - PRESS PLAY, STOP
CANCEL] (to auto install, press
to cancel, press
2
Press
to start full scan.
» The system automatically stores FM
radio stations with sufficient signal
strength.
» The first preset station is broadcast
automatically.
Tip
•
To exit storing mode, press
Set clock
1
In standby mode, press and hold CLOCK
on the remote control for two seconds.
» [SET CLOCK] (set clock) scrolls on
the display.
2
Press
/
repeatedly to select
whether to synchronize time with RDS
stations.
• [RDS TIME SYNC [Y]]: synchronize
time with RDS stations automatically.
• [RDS TIME SYNC [N]]: deactivate
time synchronization.
3
Press CLOCK to confirm.
» The 12/24 hour format blinks.
4
Repeat steps 2-3 to set the hour format,
hour and minute in sequence.
;
) is displayed.
or
.
Note
•
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
•
If the system is idle for 90 seconds, it exits clock setting
mode automatically.
Turn on
Press .
» The system switches to the last selected
source.
Tip
•
To select another source, press SOURCE repeatedly or
the source selection buttons on the remote control.
Switch to standby mode
Press
to switch the system to standby mode.
» The clock (if set) appears on the display
panel.
EN
8