Philips Emotive Micro MZ-1100 Kullanıcı El Kitabı - Sayfa 25

Stereo sistemi Philips Emotive Micro MZ-1100 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Philips Emotive Micro MZ-1100 25 sayfaları. Philips mz110037 stereo systems: specifications
Ayrıca Philips Emotive Micro MZ-1100 için: Kullanıcı El Kitabı (25 sayfalar), Kullanıcı El Kitabı (24 sayfalar), Teknik Özellikler (2 sayfalar)

Sayfayı Yazdır

Philips Emotive Micro MZ-1100 Kullanıcı El Kitabı

WARNING

Under no circumstances should you try to repair the system yourself, as this will

invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you

are unable to solve a problem by following these hints, consult your dealer or service centre.

Problem

The disc is ejected automatically.

Radio reception is poor.

The system does not react when buttons are

pressed.

Sound cannot be heard or is of poor quality.

The left and right sound outputs are reversed.

The remote control does not function

properly.

The timer is not working.

Troubleshooting

Solution

Load in the disc with label facing right.

Replace or clean the disc, see "Maintenance".

Use a finalised CD-RW or a correct MP3-CD format

disc.

If the signal is too weak, adjust the antenna or connect

an external antenna for better reception.

Increase the distance between the system and your TV

or VCR.

Remove and reconnect the AC power plug and switch

on the system again.

Adjust the volume.

Disconnect the headphones.

Check that the speakers are connected correctly.

Make sure the MP3-CD was recorded within 32-256

kbps bit rate with sampling frequencies at 48 kHz,

44.1 kHz or 32 kHz.

Check the speaker connections and location.

Select the source (MP3-CD or TUNER, for example)

before pressing the function button (É, S , T).

Reduce the distance between the remote control and

the system.

Replace the battery.

Point the remote control directly toward the IR sensor.

Set the clock correctly.

Press and hold CLK/TIMER to switch on the timer.

3139 115 21642