Toshiba TDP-S35U Kullanıcı El Kitabı - Sayfa 10

Projektör Toshiba TDP-S35U için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Toshiba TDP-S35U 25 sayfaları. Mobile projector
Ayrıca Toshiba TDP-S35U için: Teknik Özellikler (2 sayfalar), Teknik Özellikler (2 sayfalar)

Sayfayı Yazdır

Names of each part on the document camera

(1)

(2)

(3)

(6) (7)

(4)

(8)

(5)

Name

: Function

(1) Camera head

: Document camera.

(2) Camera lens

: Shooting lens for the document camera.

(3) Focusing lever

: Adjusts the focus.

(4) Camera arm

: Adjusts the shooting angle.

(5) Lock lever

: Used when the document camera is detached from the

tray.

(6) CAMERA button

: Toggles between the camera input and previous input.

p.36

(7) CAMERA GAIN buttons

: Adjusts the camera gain.

(8) Tip resistant bar

: Pulled out when a camera is used separated from the

projector.

(9) Camera output terminal

: Used connect the supplied document camera cable to

(CAMERA OUT)

the COMPUTER IN (camera) terminal of the projector.

(10) Tray

: The document camera is mounted.

(11) Lock lever

: Locks the document camera onto the tray.

(12) Lock switch

: Used when the document camera is attached/detached

to/from the tray.

(TDP-SC35)

(10)

(9)

(11)

p.36

Preparing and using the remote control

■ Loading dry-cell batteries

into the remote control

q Remove the battery cover.

(12)

w Insert the dry-cell batteries.

Be sure to align the plus and minus

ends of the batteries properly.

Two batteries (R6, SIZE AA) are used.

e Replace the battery cover.

Dry-cell batteries

• Before using the batteries, be sure to observe the Safety Precautions described in

previous pages.

• Remove batteries from remote control when not using for extended periods.

• If the remote control stops working, or if its range decreases, replace all the batteries with

new ones.

The remote control

• The remote control may fail to operate if the infrared remote sensor is exposed to bright

sunlight or fluorescent lighting.

• Do not drop or bang.

• Do not leave in hot or humid locations.

• Do not get wet or place on top of wet objects.

• Do not take apart.

• In rare cases, ambient conditions could impede the operation of the remote control. If this

happens, point the remote control at the main unit again, and repeat the operation.

■ Operating the remote

control

Point the remote control toward the

projector's infrared remote sensor,

and press a button on the remote

control.

• Operating the projector from the front

Approx. 15°

• Operating the projector from the rear

Approx. 15°