Toshiba TDP-SP1 Kullanıcı El Kitabı - Sayfa 27

Projektör Toshiba TDP-SP1 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Toshiba TDP-SP1 46 sayfaları. Tdp-sp1u user's guide

Projector placement angle adjustments

The placement angle and the height of the projected image can be adjusted by the foot

adjuster.

j Lift up the front of the projector to

the desired angle, then press the

foot adjuster release button.

The foot adjuster extends. Release the but-

ton to lock the position.

k To adjust the horizontal angle, use

the tilt adjuster.

To stow the foot adjuster, hold up the projector

while pressing the foot adjuster release button,

then slowly lower the projector.

Adjusting the screen size and focus

j Use the zooming ring to adjust the screen size.

k Use the focusing ring to adjust the focus.

Adjusting the volume with VOL+/- buttons

The speaker volume can be adjusted when an audio signal is being input.

Notes

• A lamp characteristics may rarely cause the brightness to fluctuate slightly.

• A lamp is consumable item. If used for extended periods, images will appear dark, and

the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The

lifetime of the lamp depends on conditions of use.)

• The DLP

chip is made using extremely advanced technology. There may be black spots

(pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. These

are intrinsic characteristics of the technology and are not malfunctions.

• Although this projector supports a wide range of RGB signals

supported by this projector (SVGA) will be expanded or shrunk, which will affect image

quality slightly. To view high-quality images, set the computer's external output to SVGA.

• With some models of computer having LCD displays or the like, displaying images

simultaneously on the projector and the monitor's display may prevent the images from

displaying properly. If this happens, turn off the computer's LCD display. For information

on how to turn off the LCD display, see the computer's owner's manual.

• If no signal is being input from the connected equipment or signal input is stopped while

projecting, the "No signal" message will appear.

• If a signal not supported by the projector is input, the "Unsupported signal" message

will appear.

• If an unavailable operation button is pressed, the

p.43

icon will appear.

, any resolutions not