Philips FW 355C Kullanıcı Kılavuzu - Sayfa 17
Stereo sistemi Philips FW 355C için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Philips FW 355C 29 sayfaları. Philips mini hi-fi system instructions for use
Ayrıca Philips FW 355C için: Teknik Özellikler (2 sayfalar), (Fince) El Kitabı (26 sayfalar), (Danca) Kullanım talimatları (26 sayfalar)
Sayfayı Yazdır
Random play
1
Press SHUFFLE on the remote control.
is shown and "SHUFFLE" is displayed.
SHUF
All the available discs or programmed tracks
(if programme is active) will be played in random
order.
2
To resume normal playback, press SHUFFLE
again.
disappears.
SHUF
Notes:
– During programme play or shuffling mode, it is
not possible to repeat playback the current disc
(Repeat Disc mode).
– Pressing the OPEN/CLOSE button will cancel all
repeat and shuffling modes.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading discs").
2
Press PROG to start programming.
starts flashing.
PROG
3
Press CD 1/2/3 to select a disc.
4
Press í or ë repeatedly to select the desired
track.
5
Press PROG to store the track.
Repeat steps 3–5 to store other discs and
tracks.
6
To end programming, press Ç once.
stays and the programme mode
PROG
remains active.
The total number of tracks programmed and
the total playing time are displayed.
7
To start programme play, pressÉ Å .
"PLAY PROGRAM" is displayed.
pg 001-029/C355/21-Eng
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to programme more than 40
tracks, "FULL" is displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
programme mode automatically.
To review the programme
Stop playback and pressí or ë repeatedly.
To exit review mode, press Ç.
Erasing the programme
Press Ç once when playback is stopped or
twice during playback.
PROG
is displayed.
Note:
– The programme will be erased when the system
is disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to "Tape
Operation/Recording".
17
CD Operation
disappears and "PROGRAM CLEARED"
3139 115 21381
12/24/01, 11:17 AM
17