MSI E7210 Master-FARM Kullanıcı Kılavuzu - Sayfa 14
Sunucu Panosu MSI E7210 Master-FARM için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. MSI E7210 Master-FARM 34 sayfaları. (v1.x) atx server board
Sayfayı Yazdır
MS-9149 ATX Server Board
Back Panel
Parallel
Mouse
USB
Keyboard
COM A
KB/Mouse Connector
VGA Port
VGA Connector
(DB 15-pin)
USB Ports
COM2
PIN
SIGNAL
1
VCC
2-10
VGA
LAN1
LAN2
RJ-45 LAN Jack
8
1
Gigabit LAN Pin Definition
1
D0P
Differential Pair 0+
2
D0N
Differential Pair 0-
3
D1P
Differential Pair 1+
4
D2P
Differential Pair 2+
5
D2N
Differential Pair 2-
6
D1N
Differential Pair 1-
7
D3P
Differential Pair 3+
8
D3N
Differential Pair 3-
Serial Ports
PIN
SIGNAL
Connectors, Jumpers & Slots
Floppy Disk Drive Connector: JFDD1
The mainb oard provides a stand ard floppy disk d rive connector t hat
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
Hard Disk Connectors: IDE1/2
The mainboard has a 32-bit Enhan ced PCI IDE an d Ultra DMA 33/66/
100 co ntroller t hat provid es PIO mod e 0~4, Bus Master, and Ultra DMA 33/
66/100 fun ction. Yo u can co nnect u p to fo ur h ard dis k drives, CD-ROM,
120MB Floppy (reserved for future BIOS) and other devices. These connec-
tors support the provid ed IDE hard disk cable.
JFDD1
IDE1 (Primary IDE Connector)
The first hard drive should always be connected t o IDE1. IDE1 can
connect a Master and a Slave driv e. You must configure seco nd hard
drive to Slave mode by setting the jumper accordingly.
IDE2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install t wo hard disks on cable, you mu st configure the
second d rive to Slave mode by setting i ts jumper. Refer to the
hard disk documentatio n suppl ied by hard disk vendors for
jumper setting instructions.
Hardware Setup
IDE2
IDE1
2-11