Epson WorkForce 600 Series Ağ Kurulum Kılavuzu - Sayfa 3

Yazılım Epson WorkForce 600 Series için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Epson WorkForce 600 Series 41 sayfaları. Using the control panel for wireless network installation
Ayrıca Epson WorkForce 600 Series için: Kullanıcı Kılavuzu (34 sayfalar), Kullanıcı Kılavuzu (38 sayfalar), Kartuşların Değiştirilmesi (2 sayfalar), Önemli Kurulum Bilgileri (2 sayfalar), Teknik Özellikler (2 sayfalar), Buradan Başlayın Kılavuzu (9 sayfalar), Ürün Destek Bülteni (5 sayfalar), İşlev Kılavuzu (28 sayfalar)

Wireless Network Installation

To add the printer to your wireless network, you need to know the name (SSID)

of your wireless network. If it has security enabled, you also need to know the

WEP key or passphrase. Write down the SSID and WEP key or passphrase below:

■

Network name (SSID): _________________________________________

■

WEP key or passphrase: _________________________________________

Note:

If the WEP key is either 5 or 13 characters, it's ASCII. If the WEP key is either 10 or 26

characters, it's hexadecimal. The default WEP key is usually 1.

If your passphrase contains upper- or lowercase letters, be sure to note it correctly.

The printer supports the following wireless security modes: WEP 64, WEP 128, and

WPA-PSK.

If you don't know your wireless network name (SSID) or WEP key or passphrase,

contact the person who set up your wireless network before you begin.

Note:

This is a temporary connection used to configure the printer. You will be prompted to

remove the cable when configuration is complete.

1. Connect an Ethernet network cable to the

(

port on your printer.

LAN

10/100)

Wireless Network Installation