Dimplex CXLS12N Kurulum Talimatları Kılavuzu - Sayfa 7

Isıtıcı Dimplex CXLS12N için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Dimplex CXLS12N 8 sayfaları. Ultra-slim automatic storage and convector heaters
Ayrıca Dimplex CXLS12N için: Kullanım Talimatları (5 sayfalar), Kurulum Talimatları Kılavuzu (8 sayfalar), Kullanım Talimatları (5 sayfalar), Kullanım Talimatları Kılavuzu (11 sayfalar)

31. Check that the damper mechanism within the heater functions freely,

by rotating the left hand control knob. Check also that the right hand (input)

knob rotates freely.

34. Push the bottom of the front panel towards the heater, such that the

bottom ﬂ ange locates under the base.

32. Select the convector heater load appropriate to your recommended

heating design scheme by, if necessary, disconnecting one convector

element by moving either the brown or mauve wire to the empty barrel on

the white terminal block on the internal bafﬂ e.

Model

Brown Wire

Still in Circuit

(Upper Element)

450W

#CXL12N/CXLS12N

450W

#CXL18N/CXLS18N

650W

CXL24N/CXLS24N

#Note: if the heater is situated underneath a shelf or overhand up to 250mm

high, then the brown wire should remain in circuit.

33. Holding the bottom edge if the front panel towards you, locate the top

edge of the front panel in the groove at the top of the heater and ensure

that the locating pegs on the rear ﬂ anges of the front panel are located in

the receiving holes in each side panel.

35. Replace the two front panel securing screws removed in operation 15. A small mirror

placed on the ﬂ oor under the heater will help location of the threaded holes in the base. These

may be screwed in by hand most of the way, but should then be tightened using an 8mm AF

socket or open ended spanner.

Mauve Wire

Both in

Still in Circuit

Circuit

(Lower Element)

450W

900W

1000W

1450W

1350W

2000W