3Com 8250 Dönüşüm Kılavuzu - Sayfa 5

Kablosuz Erişim Noktası 3Com 8250 için çevrimiçi göz atın veya pdf Dönüşüm Kılavuzu indirin. 3Com 8250 10 sayfaları. Converting to managed access point operation
Ayrıca 3Com 8250 için: Veri Sayfası (4 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Performing the MAP Conversion Process

NOTE: Any configuration that the access point has prior to conversion to MAP mode is lost

during the conversion process.

NOTE: 3Com does not recommend using the 3ND Agent Upgrade facility when converting

access points to MAP operation. 3ND is unable to verify the conversion and will assume that

the conversion failed.

NOTE: If an AP8250 has been upgraded to an AP8750 by adding a second radio, the MAP

must be configured as an AP8750 on 3WXM and the Wireless Switch.

Before you can convert the access points, you need the 3Com Wireless Infrastructure Device Manager

and the MAP Conversion Software installed on a PC. This software is available on the CD that is provided

with the Wireless Switch; it may also be downloaded from the 3Com web site at www.3com.com.

Conversion in a Stand-Alone Network

This section assumes that you are converting an access point that has its factory default settings. A

configured device may be reset to factory defaults by pressing and holding the Reset button for 15 seconds.

Connect the access point and the PC via a switch or hub. No other devices should be

present on this network. Provide power to the access point. In the absence of a DHCP

server, it takes the access point up to one minute before it becomes manageable.

Launch the 3Com Wireless Infrastructure Device Manager, select the network adapter (if

required), and refresh the display.

Select the device to be converted in the Wireless Network Tree.

After the correct device has been selected, click Configure. Accept the suggested

IP address configuration for the access point. Leave the password field blank and click

Next. This launches the web management interface for the device.

Enter the username and password when prompted. The default username is admin and

the password field should be left blank. You also need to set the country code before

you can access the home page.

Click Advanced Setup, select the Administration page, and then go to the

Firmware Upgrade section.

Since the MAP Conversion Software is already loaded on the PC, it can be uploaded to

the access point using the Local option. Click the Browse button and locate the MAP

Conversion Software file. Click Start Upgrade to start the conversion process. The

upload takes place through the HTTP protocol from the local machine.

When the upload is complete, click Reboot. The Power LED on the access point will flash

yellow. The web management interface can be dismissed and the process repeated for

other access points that also need to be converted.