CRRC MS-JY111-L Kullanım Kılavuzu - Sayfa 2

Endüstriyel Ekipmanlar CRRC MS-JY111-L için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CRRC MS-JY111-L 10 sayfaları. Hydraulic unit

Sayfayı Yazdır
Notice
1.
Please read and understand the warning/caution label.
2.
Only the personnel who have trained by Meishan CRRC Fastening System Company as well as
learned this manual are allowed to operate this pump.
3.
If any other information is required, please contact Meishan.
Warning
1.
Please wear eye protection.
2.
Only the approved part or components can be used for maintenance or repair.
3.
This pump cannot be used in flammable environment.
Safety Instruction
1.
A half hour long hands-on training session with qualified personnel is recommended before
using Meishan equipment.
2.
Meishan equipment must be maintained in a safe working condition at all times. Tools and
hoses should be inspected at the beginning of each shift/day for damage or wear. Any repair should be
done by a qualified repairman trained on Meishan procedures.
3.
Repairman and Operator must read manual prior to using equipment. Warning and Caution
stickers/labels supplied with equipment must be understood before connecting equipment to any
primary power supply. As applicable, each of the sections in this manual have specific safety and other
information.
4.
Read MSDS Specifications before servicing the tool. MSDS Specifications are available
from the product manufacturer or your Meishan representative.
5.
When repairing or operating Meishan installation equipment, always wear approved eye
protection.
6.
Only genuine Meishan parts shall be used for replacements or spares. Use of any other parts
can result in tooling damage or personal injury.
7.
If a part affixed with warning labels is replaced, or labels are missing or damaged, the end
user is responsible for replacement. Refer to assembly drawing and parts list for replacement part
number and proper placement.
8.
Disconnect primary power source before performing maintenance on Meishan equipment or
changing Nose Assembly.
9.
Tools and hoses should be inspected for leaks at the beginning of each shift/day. If any
equipment shows signs of damage, wear, or leakage, do not connect it to the primary power supply.
10.
Mounting hardware should be checked at the beginning of each shift/day.
11.
Make sure proper power source is used at all times.