CRU Dataport 25 SL Kurulum Kılavuzu

Depolama CRU Dataport 25 SL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. CRU Dataport 25 SL 2 sayfaları.

DataPort 25 SL Install Guide

The DataPort 25 SL is a low profile DataPort designed to fit into

small form factor 3.5" drive bays. The DataPort 25 SL holds one

SATA 2.5" hard drive.

Installing the frame into your computer

1. Locate an available 3.5" drive bay and remove the front bezel.

2. If your computer requires mounting rails, install the rails on the

DataPort 25 SL frame and slide it into the computer and ensure

it is properly secured.

3. If your computer does not require mounting rails slide the

DataPort 25 SL frame into the computer drive bay and

secure it with the provided mounting screws.

4. Locate and connect an available 4-pin power connector (used

for floppy drives) to the back of the DataPort 25 SL frame.

5. Locate an available SATA data cable and connect it to the back

of the DataPort 25 SL frame to the left most SATA connector

(see picture for details).

Use this SATA data connector

Your frame installation is complete.

Installing a hard drive in your DataPort 25 SL Carrier

1. Remove the two screws from the back of the SL Carrier. Slide

the metal cover off. Note: Do NOT use screws longer than

those supplied as the circuit board will be damaged.

2. Install the hard drive upside-down. Connect the hard drive

3. Slide the cover back on to the carrier and secure it with the

Operation

Power connector

Warning! Please do not touch the connector on the back

of the carrier. Internal damage could result from electro-

static discharge.

1-800-260-9800

Rugged, Reliable, Mobile, Secure

(upside-down) to the connector on the circuit board with the

bottom of the hard drive facing upwards. Then use the pro-

vided screws to secure the hard drive.

cover screws.

Warning! The DataPort 25 SL is not interchangeable with

any other DataPort 25 products. Due to size limitations

the DataPort 25 SL carrier will not fit properly into other

DataPort 25 frames. Any attempt to do so could result in

the loss of data. The DataPort 25 SL frame will only sup-

port the DataPort 25 SL carrier. Any other carrier will not fit

properly into the DataPort 25 SL and could damage it.