CRU DataPort 30 Kurulum Kılavuzu

Raflar ve Standlar CRU DataPort 30 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. CRU DataPort 30 2 sayfaları. Serial ata installation guide

Sayfayı Yazdır

DataPort 30 Serial ATA Installation Guide

The DataPort 30 provides a high quality removable drive en-

closure for an attractive price. The compact design allows the

DataPort 30 to fit into most desktops and mini-tower 5.35" drive

bays. The DataPort 30's rugged design and 25k insertion rated

connector make for a great product with a low price.

Package Contents:

1 – DataPort 30 Frame Assembly

1 – DataPort 30 Carrier Assembly

1 – Mounting Screw Kit

1 – Set of Keys

Mounting the Frame in the Computer

1. Turn off the computer and disconnect its power cord from the

electrical outlet. Before working on your computer, wait one

minute for any residual energy to dissipate. Ground yourself

and then remove the cover of the computer. Determine the

5.25" half-height bay where you plan to mount the DataPort

frame assembly. Remove any filler plates that may be present.

2. To mount the frame assembly in the drive bay:

a. Check the drive bay to see if mounting rails are required

(they should be provided by your computer system

manufacturer.) If required, install one on each side of the

frame. Then slide the frame in the computer and check

that it is secure.

b. If mounting rails are not required, attach the frame

Directly to the PC case using the screws provided. Either

the side or bottom mount holes on the frame may be

used.

3. Locate a SATA data cable and connect it to the SATA connector

on the frame.

4. Locate an available 15-pin SATA or 4-pin Molex power cable

from the computer power supply and plug it into the power

connector on the frame.

Rugged, Reliable, Mobile, Secure

Installing a Hard Drive in the Carrier

1. Remove the top cover of the carrier.

Remove the screw securing the cover and slide the top cover

off the DataPort 30 carrier (see figure 1).

Figure 1: Removing the Cover

2. Install the hard drive in your carrier.

Slide the hard drive in from the front of the carrier and connect it

to the carrier board (see figure 2). When the hard drive is properly

connected, the rear side mount screw holes will be aligned. Use

the screws provided to secure the hard drive in the carrier.

rear screw holes

Figure 2: Installing the drive

1-800-260-9800