Dimplex MILANOef EDS7001F Parça ve Servis Kılavuzu - Sayfa 3
Soba Dimplex MILANOef EDS7001F için çevrimiçi göz atın veya pdf Parça ve Servis Kılavuzu indirin. Dimplex MILANOef EDS7001F 17 sayfaları. Dimplex milano stove parts and service manual
Ayrıca Dimplex MILANOef EDS7001F için: Parça ve Servis Kılavuzu (17 sayfalar)
Sayfayı Yazdır
ef
EDS7001F MILANO
NOTE
A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not
essential in all cases. A dedicated circuit will be required if, after installation, the
circuit breaker trips or fuse blows on a regular basis when the heater is
operating. Additional appliances on the same circuit may exceed the current
rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp
edge and ensure that the power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes
and other applicable regulations to reduce the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire,
electric shock or injury to persons, always use a licensed electrician.
ef
MILANO
INSTALLATION
1. Make sure the unit is switched OFF (refer to operating instruction section).
2. Plug the unit into a 15Amp/120volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 watts.
OPERATION
To access the controls go to the back of the milano
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to all unit functions (heat/flame)
B. HEATER ON/OFF SWITCH
The HEATER ON/OFF SWITCH supplies power to the heater fan and the
heater element.
C. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the thermostat
control clockwise all the way to turn on the heater. When the room reached the
desired temperature, turn the thermostat knob counter clockwise until you hear
a click. Leave in this position to maintain the room temperature at this setting.
For additional heat, turn clockwise until you hear the click again and the heater
will turn on. To turn the heater off, switch the HEATER ON/OFF SWITCH to
the OFF position.
NOTE:- When the heater is switched ON, the heater fan will operate. The heater
element may or may not be on, depending on the thermostat control setting (SEE
"HEATER THERMOSTAT CONTROL").
ef
.
back of the milano
3
ef