Dimplex TDS8515T Kurulum ve Kullanım Kılavuzu - Sayfa 14
Soba Dimplex TDS8515T için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Dimplex TDS8515T 17 sayfaları. Purifire electric stove
Sayfayı Yazdır
- 1. Table of Contents
- 2. Operation
- 3. Parts Drawing
- 4. Replacement Parts
- 5. Parts List
- 6. Upper Light Bulb Replacement
- 7. Lower Light Bulb Replacement
- 8. Filter Replacement
- 9. Main On/Off Switch Replacement
- 10. Manual Selection Switch Replacement
- 11. Upper Light On/Off Switch Replacement
- 12. Heater Assembly Replacement
- 13. Circuit Board Replacement
- 14. Flame Motor/Flame Rod Replacement
- 15. Power Cord Replacement
- 16. Thermostat Replacement
TDS8515T
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/FLAME ROD
1. Gently place stove on it's back on a flat surface.
2. Remove the thermostat knob.
3. Remove the heater cover retaining screws located on the bottom of the stove and
lower heater/light assembly onto the floor.
4. Remove the reflector rod from the flame motor by pulling the end of the rod to the
left and separating it from the rubber sleeve.
5. Remove the rubber sleeve from the motor shaft.
6. Remove the 2 motor mounting screws and remove the flame motor.
7. Discard the old flame motor.
8. Lay the stove on its back with the front window facing upward.
9. Remove the bottom heater assembly cover being careful not to damage any of the
wiring and lay it on the floor.
10. Loosen the flame motor connections on the terminal block and remove the wires
noting their original locations.
11. Reassemble in the reverse order.
13