Aeon Labs AEO MULTISENS Hızlı Başlangıç Kılavuzu - Sayfa 3

Güvenlik Sensörleri Aeon Labs AEO MULTISENS için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Aeon Labs AEO MULTISENS 8 sayfaları. Z-wave motion sensor, temperature sensor, humidity sensor and lightness sensor in one package

Sayfayı Yazdır

Behavior within the Z-Wave network

On factory default the device does not belong to any Z-Wave network. The device needs to join an

existing wireless network to communicate with the devices of this network. This process is called Inclusion.

Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the

primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion

mode. Please refer to your primary controllers manual on how to turn your controller into inclusion or

exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave

the network. Leaving the network - i.e. being excluded - sets the device back to factory default.

If the device already belongs to a network, follow the exclusion process before including it in your network.

Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to

be reset first.

Make sure that your Z-Wave Controller is in the Inclusion-/Exclusion-Mode. Click the little button behind the

battery to confirm the process.