Aeon Labs Aeotec MULTISENSOR 6 Manuel - Sayfa 10

Güvenlik Sensörleri Aeon Labs Aeotec MULTISENSOR 6 için çevrimiçi göz atın veya pdf Manuel indirin. Aeon Labs Aeotec MULTISENSOR 6 14 sayfaları.
Ayrıca Aeon Labs Aeotec MULTISENSOR 6 için: Kullanıcı Kılavuzu (11 sayfalar)

Sayfayı Yazdır

For optimal performance, your MultiSensor should NOT be

mounted directly on or near metal framing or other large metallic

objects. Large metal objects may weaken the Z-Wave wireless

signal.

If selecting an outdoor location, it's important to position your

MultiSensor in a sheltered location. It is best if your MultiSensor

is not directly exposed to rain, and is important that the humidity

venting on your MultiSensor never is.

Physically install your MultiSensor.

With your MultiSensor now part of your Z-Wave network, it's time to

finish its physical installation.

There are 2 ways that your MultiSensor can be mounted on on a

wall or ceiling. Using the Back-Mount Plate, you can mount it flat

against a wall or ceiling. Using the Back-Mount Arm you can mount

it on a surface or in a corner and angle it as desired.

To physically install your MultiSensor;

Reattach the two parts of your MultiSensor to each other. To do

this, align the lock/unlock half-dimple markers that are under the

unlock symbol and then twist in a clockwise motion.

If USB is used to power your MultiSensor, ensure that power

can be provided to your desired installation location. Please note

that when installed in areas that where the temperature can drop

below -10°C, it is advised that USB power is used and battery

power is not.

The MultiSensor contains a smart Vibration sensor in. When

someone attempts to disassemble your MultiSensor, it can detect

the vibration and send an alarm notification to the main controller

and let you know.

Security or Non-security feature of your MultiSensor in

Z-wave network.

If you want your MultiSensor as a non-security device in your

Z-wave network, you just need to press the Action Button once on

MultiSensor when you use a controller/gateway to add/include your

MultiSensor.

In order to take full advantage of all functionality the MultiSensor,

you may want your MultiSensor is a security device that uses

secure/encrypted message to communicate in Z-wave network, so

a security enabled controller/gateway is needed for the Multisensor

to be used as a security device.You need to press the MultiSensor's

Action Button 2 times within 1 second when your security controller/

gateway starts the network inclusion.

Resetting your MultiSensor.

At some stage or your primary controller is missing or inoperable,

you may also wish to reset all of your MultiSensor's settings to their

factory defaults. To do this, press and hold the Z-Wave Button for

20 seconds and then release it. Your MultiSensor will now be reset

to its original settings, and the LED will stay solid for 2 seconds and

then turn off as a confirmation.