Pioneer AVG-VDP1 Kurulum Kılavuzu - Sayfa 13

Araç Alıcısı Pioneer AVG-VDP1 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer AVG-VDP1 30 sayfaları. Vehicle dynamics processor
Ayrıca Pioneer AVG-VDP1 için: Manuel (39 sayfalar)

Sayfayı Yazdır

Installing the GPS antenna

CAUTION:

• Do not cut the GPS antenna lead

to shorten it or use an extension

to make it longer. Altering the

antenna cable could result in a

short circuit or malfunction and

permanent damage to the prod-

uct.

Installation notes

• The antenna should be installed on a level

surface where radio waves will be blocked

as little as possible. Radio waves cannot be

received by the antenna if reception from

the satellite is blocked.

Installation on the vehicle roof or trunk lid is

recommended to optimise reception.

Roof

• When installing the GPS antenna inside the

vehicle, be sure to use the metal sheet

provided with your system. If this is not

used, the reception sensitivity will be poor.

• Do not cut the accessory metal sheet. This

would reduce the sensitivity of the GPS

antenna.

• Take care not to pull the antenna lead when

removing the GPS antenna. The magnet

attached to the antenna is very powerful, and

the lead may become detached.

Trunk lid

Rear shelf

• The GPS antenna is installed with a magnet.

When installing the GPS antenna, be careful

not to scratch the vehicle body.

• When installing the GPS antenna on the out-

side of the vehicle, always put it in the vehi-

cle when going through an automatic vehi-

cle wash. If it is left on the outside it may be

knocked off and scratch the vehicle body.

• Do not paint the GPS antenna, as this may

affect its performance.