Pioneer CX-3283 Servis Kılavuzu - Sayfa 31

Araç Alıcısı Pioneer CX-3283 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Pioneer CX-3283 32 sayfaları. Dvd mechanism module ls2

3.12 HOW TO REMOVE THE DRIVE LEVER ASSY

1. According to "3.10 HOW TO REMOVE THE CRG MECHANISM ASSY", remove the CRG Mechanism ASSY.

(Mechanism – Eject status)

2. According to "3.13 HOW TO REMOVE AND INSTALL THE CLAMP ARM ASSY", remove the Clamp Arm ASSY.

3. Remove the Biasing Spring of Drive Lever (Fig.1) .

4. Slide the Drive Lever in the direction of arrow (eject direction), hold it up in the direction of upper right and remove it (Fig.2).

(Note) When the Drive Lever ASSY is reinstalled, in the state where A-part of Fig.3 is completely moved to the direction of

arrow (*1), first install B-part (Fig.2), install C-part of the Drive Lever (Fig.4) in the groove of Chassis side bend, and

finally install D-part (Fig.4) in the L-shaped groove of Chassis. And then slide the Drive Lever to the state of Fig.1

*1: If A-part (Fig.3) is not moved sufficiently, the Drive Lever cannot be engaged suitably.

In this case, the Idle Gear may be on the position of red broken line (Fig.5),

so move A-part (Fig.3) to the direction of arrow while moving the Idle Gear

to the direction of arrow (Fig.5)

Judge sufficient movement of A-part based on the position of C-part of Fig.5.

Biasing Spring of Drive Lever

Fig.1

Idle Gear

C-part: NG position

Position of insufficient

movement

C-part: OK position

Position of sufficient

movement

Fig.2

Fig.5

CX-3283

Fig.3

Fig.4

http://www.Datasheet4U.com