Pioneer DEH-1200MP Kullanıcı El Kitabı - Sayfa 10

Araç Alıcısı Pioneer DEH-1200MP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer DEH-1200MP 21 sayfaları. Cd receiver

Sayfayı Yazdır

Section

II (

Connections

WARNING

•

Use speakers over 50 W (output value) and be-

tween 4

to 8

(impedance value). Do not

use 1

to 3

speakers for this unit.

•

The black cable is ground. When installing

this unit or power amp (sold separately), make

sure to connect the ground wire first. Ensure

that the ground wire is properly connected to

metal parts of the car's body The ground wire

of the power amp and the one of this unit or

any other device must be connected to the car

separately with different screws. If the screw

for the ground wire loosens or falls out. it

could result in fire, generation of smoke or

malfunction.

G, o s:"e

i i

~MP

L)t:r:-

Other devices

Metal parts of car's body

(Another electronic

device

in the car)

Important

•

When Installing thiS unit in a vehicle without

an ACC (accessory) position on the ignition

switch, failure to connect the red cable to the

terminal that detects operation of the ignition

key may result in battery drain.

)

Secure the wiring with cable clamps or ad-

hesive tape. Wrap adhesive tape around

wiring that comes into contact with metal

parts to protect the wiring.

Place all cables away from moving parts,

such as the gear shift and seat rails.

Place all cables away from hot places.

such as near the heater outlet.

Do not connect the yellow cable to the bat-

tery by passing it through the hole to the

engine compartment.

Cover any disconnected cable connectors

with insulating tape.

Do not shorten any cables.

Never cut the insulation of the power cable

of this unit in orderto share the power

with other devices. The current capacity of

the cable is limited.

Use a fuse of the rating prescribed.

Never wire the negative speaker cable di-

rectly to ground,

Never band together negative cables of

multiple speakers,

•

When this unit is on. control signals are sent

through the blue/white cable. Connect this

cable to the system remote control of an exter-

nal power amp or the vehicle's auto-antenna

relay control terminal (max. 300 mA 12 V DC).

If the vehicle is equipped with a glass anten-

na, connect It to the antenna booster power

supply terminal.

•

Never con nect the bl ue/wh ite cable to the

powerterminal of an external power amp,

Also. never connect it to the power terminal of

the auto antenna. Doing so may result in bat-

tery drain or a malfunction.

ACC position

No ACC positio

•

Use this unit with a 12-volt battery and nega-

tive grounding only. Failure to do so may result

in a fire or malfunction.

• To prevent a short-circuit. overheating or mal-

function. be sure to follow the directions

below.

Disconnect the negative terminal of the

battery before installation.