Pioneer DEH-1730R Kullanım Kılavuzu - Sayfa 4

Araç Alıcısı Pioneer DEH-1730R için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Pioneer DEH-1730R 8 sayfaları. High power cd player with rds tuner

Sayfayı Yazdır

CRD3902-A/N -Page 4-

Initial Settings

Adjusting initial settings

Press c or d to select the FM tuning

step.

Press c to select 50 (50 kHz). Press d to se-

lect 100 (100 kHz).

Switching Auto PI Seek

The unit can automatically search for a differ-

Initial settings lets you perform initial setup of

ent station with the same programming, even

different settings for this unit.

during preset recall.

1 Function display

Shows the function status.

Press AUDIO to select A-PI.

Press + or to turn the Auto PI seek on

Press SOURCE and hold until the unit

or off.

turns off.

Press SOURCE and hold until FM ap-

pears in the display.

Saving the battery

Press AUDIO to display the function

consumption

names.

It is possible to save the battery consumption

Press AUDIO repeatedly to switch between

when this unit is turned off. After one minute

the following settings:

of turning off this unit, this unit will be

FM (FM tuning step)A-PI (Auto PI Seek)

switched into power save mode.

SAVE (Power save)

! You cannot insert and eject a disc while

Use the following instructions to operate each

this unit is in power save mode.

particular setting.

! You can only use SOURCE while this unit is

# To cancel initial settings, press BAND.

in power save mode.

# You can also cancel initial settings by holding

down SOURCE until the unit turns off.

Important

When you disconnect a battery in order to replace

it, this mode is turned off. When installing this

Setting the FM tuning step

unit in a vehicle that does not have an ACC (ac-

Normally the FM tuning step employed by

cessory) position on the ignition switch, the vehi-

seek tuning is 50 kHz. When AF or TA is on,

cle battery may be drained depending on a

the tuning step automatically changes to 100

connection method. After checking the connec-

kHz. It may be preferable to set the tuning step

tion method, turn this mode on if needed.

to 50 kHz when AF is on.

! The tuning step remains at 50 kHz during

Press AUDIO to select SAVE.

manual tuning.

Press + or to turn power save on or

Press AUDIO to select FM.

off.

Additional Information

Understanding built-in CD

! Store discs in their cases when not in use.

! Keep discs out of direct sunlight and do

player error messages

not expose the discs to high temperatures.

When you contact your dealer or your nearest

! Do not attach labels, write on or apply che-

Pioneer Service Center, be sure to record the

micals to the surface of the discs.

error message.

! To clean a CD, wipe the disc with a soft

cloth outward from the center.

Message

Cause

Action

ERROR-11, 12,

Dirty disc

Clean disc.

17, 30

ERROR-11, 12,

Scratched disc

Replace disc.

17, 30

ERROR-10, 11,

Electrical or me-

Turn the ignition

12, 17, 30, A0

chanical

ON and OFF, or

! If the heater is used in cold weather, moist-

switch to a differ-

ure may form on components inside the

ent source, then

CD player. Condensation may cause the CD

back to the CD

player to malfunction. If you think that con-

player.

densation is a problem turn off the CD

ERROR-44

All tracks are

Replace disc.

skip tracks

player for an hour or so to allow it to dry

out and wipe any damp discs with a soft

cloth to remove the moisture.

! Road shocks may interrupt CD playback.

CD player and care

! Use only CDs that have the Compact Disc

CD-R/CD-RW discs

Digital Audio mark as show below.

! When CD-R/CD-RW discs are used, play-

back is possible only for discs which have

been finalized.

! It may not be possible to play back CD-R/

! Use only normal, round CDs. If you insert ir-

CD-RW discs recorded on a music CD re-

regular, non-round, shaped CDs they may

corder or a personal computer because of

jam in the CD player or not play properly.

disc characteristics, scratches or dirt on

the disc, or dirt, condensation, etc., on the

lens of this unit.

! Playback of discs recorded on a personal

computer may not be possible, depending

on the application settings and the environ-

! Check all CDs for cracks, scratches or

ment. Please record with the correct for-

warping before playing. CDs that have

mat. (For details, contact the manufacturer

cracks, scratches or are warped may not

of the application.)

play properly. Do not use such discs.

! Avoid touching the recorded (non-printed)

surface when handling the disc.

! Playback of CD-R/CD-RW discs may be-

come impossible in case of direct exposure

to sunlight, high temperatures, or the sto-

rage conditions in the vehicle.

! This unit conforms to the track skip func-

tion of the CD-R/CD-RW disc. The tracks

containing the track skip information are

skipped automatically.

! If you insert a CD-RW disc into this unit,

time to playback will be longer than when

you insert a conventional CD or CD-R disc.

! Read the precautions with CD-R/CD-RW

discs before using them.

Specifications

Signal-to-noise ratio ............... 75 dB (IEC-A network)

Distortion ..................................... 0.3 % (at 65 dBf, 1 kHz,

General

stereo)

0.1 % (at 65 dBf, 1 kHz,

Power source ............................. 14.4 V DC (10.8 15.1 V al-

mono)

lowable)

Frequency response ............... 30 15,000 Hz (±3 dB)

Grounding system ................... Negative type

Max. current consumption

Stereo separation .................... 45 dB (at 65 dBf, 1 kHz)

..................................................... 10.0 A

Selectivity .................................... 80 dB (±200 kHz)

Dimensions (W × H × D):

MW tuner

Chassis ............................... 178 × 50 × 157 mm

Nose ..................................... 188 × 58 × 18 mm

Frequency range ...................... 531 1,602 kHz (9 kHz)

Weight .......................................... 1.3 kg

Usable sensitivity ..................... 18 µV (S/N: 20 dB)

Signal-to-noise ratio ............... 65 dB (IEC-A network)

Audio

LW tuner

Maximum power output ....... 45 W × 4

Continuous power output ... 25 W × 4 (DIN 45324,

Frequency range ...................... 153 281 kHz

+B=14.4 V)

Usable sensitivity ..................... 30 µV (S/N: 20 dB)

Load impedance ...................... 4 W (4 8 W allowable)

Signal-to-noise ratio ............... 65 dB (IEC-A network)

Preout max output level/output impedance

..................................................... 2.2 V/1 kW

Note

Bass/Treble:

Bass

Specifications and the design are subject to pos-

Frequency ................ 100 Hz

sible modifications without notice due to im-

Gain ............................ ±12dB

provements.

Treble

Frequency ................ 10 kHz

Gain ............................ ±12dB

Loudness contour

Low ....................................... +7 dB (100 Hz), +4 dB (10

kHz)

High ..................................... +10 dB (100 Hz), +6.5 dB

(10 kHz)

(volume: 30 dB)

CD player

System .......................................... Compact disc audio system

Usable discs .............................. Compact disc

Signal format:

Sampling frequency ..... 44.1 kHz

Number of quantization bits

........................................... 16; linear

Frequency characteristics ... 5 20,000 Hz (±1 dB)

Signal-to-noise ratio ............... 94 dB (1 kHz) (IEC-A net-

work)

Dynamic range ......................... 92 dB (1 kHz)

Number of channels .............. 2 (stereo)

FM tuner

Frequency range ...................... 87.5 108.0 MHz

Usable sensitivity ..................... 8 dBf (0.7 µV/75 W, mono,

S/N: 30 dB)

50 dB quieting sensitivity ..... 10 dBf (0.9 µV/75 W, mono)