Pioneer DEH-4090MP Kullanıcı El Kitabı - Sayfa 18

Araç Alıcısı Pioneer DEH-4090MP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer DEH-4090MP 34 sayfaları.

Sayfayı Yazdır

Section

Audio Adjustments

Press MULTI-CONTROL to select the seg-

ment you wish to set.

Press MULTI-CONTROL repeatedly to switch

the segment in the following order:

Cut off frequency—Level

Turn MULTI-CONTROL to adjust the se-

lected segement.

Cut off frequency

50HZ—63HZ—80HZ—100HZ—125HZ

Level

+6 to –24 is displayed as the level is increased

or decreased.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Note

You can also switch to this setting mode in the

menu that appears by using

MULTI-CONTROL.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn on the

HPF (high pass filter). Only frequencies higher

than those in the selected range are output

from the front or rear speakers.

Use MULTI-CONTROL to select HPF.

Press MULTI-CONTROL to display the

setting mode.

Use MULTI-CONTROL to select the de-

sired setting.

Turn to change the setting.

OFF—50HZ—63HZ—80HZ—100HZ—125HZ

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Boosting the bass

Bass boost function boosts the bass level of

sound.

Press and hold BASS to display

BASS BOOST setting mode.

Turn MULTI-CONTROL to adjust the

level.

0 to +6 is displayed as the level is increased or

decreased.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Note

You can also switch to this setting mode in the

menu that appears by using

MULTI-CONTROL.

Adjusting source levels

SLA (source level adjustment) lets you adjust

the volume level of each source to prevent ra-

dical changes in volume when switching be-

tween sources.

! Settings are based on the FM volume level,

which remains unchanged.

Compare the FM volume level with the

level of the source you wish to adjust.

Use MULTI-CONTROL to select

SRC LV ADJUST.

Press MULTI-CONTROL to display the

setting mode.

Turn MULTI-CONTROL to adjust the

source volume.

SLA +4 to SLA –4 is displayed as the source

volume is increased or decreased.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Note

The AM volume level can also be adjusted with

source level adjustments.