Pioneer DEH-P3100 Kurulum Kılavuzu - Sayfa 4

Araç Alıcısı Pioneer DEH-P3100 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer DEH-P3100 6 sayfaları. Multi-cd control high power cd playerwith fm/am tuner

Sayfayı Yazdır

Installation

Note:

• Before finally installing the unit, connect the

• If installation angle exceeds 60° from horizontal,

wiring temporarily, making sure it is all connected

the unit might not give its optimum performance.

up properly, and the unit and the system work

(Fig. 3)

properly.

• Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts

can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifications

of the vehicle.

• Install the unit where it does not get in the driver's

way and cannot injure the passenger if there is a

sudden stop, like an emergency stop.

• The semiconductor laser will be damaged if it

overheats, so don't install the unit anywhere hot —

for instance, near a heater outlet.

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit

chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush (Fig. 4)

Holder

After inserting the holder into the dash-

board, then select the appropriate tabs

according to the thickness of the dash-

Dashboard

board material and bend them.

(Install as firmly as possible using the

182

top and bottom tabs. To secure, bend

the tabs 90 degrees.)

Rubber bush

Screw

Removing the Unit (Fig. 5) (Fig. 6)

Frame

Insert the release pin into the hole in

the bottom of the frame and pull out

to remove the frame.

(When reattaching the frame, point

the side with a groove downwards

and attach it.)

Fig. 3

Insert the supplied extraction keys

into the unit, as shown in the figure,

until they click into place.Keeping

the keys pressed against the sides of

the unit, pull the unit out.

Fig. 4

DIN Rear-mount

Installation using the screw holes on the side of the unit

1. Remove the frame. (Fig. 7)

Frame

Insert the release pin into the hole in

the bottom of the frame and pull out

Fig. 5

to remove the frame.

(When reattaching the frame, point

the side with a groove downwards

and attach it.)

Fig. 6

2. Fastening the unit to the factory radio mounting bracket.

(Fig. 8) (Fig. 9)

Select a position where the screw holes of the bracket and

the screw holes of the head unit become aligned (are fit-

ted), and tighten the screws at 2 places on each side. Use

either truss screws (5 8 mm) or flush surface screws

(5 9 mm), depending on the shape of the screw holes in

the bracket

Fig. 7

Factory radio mounting bracket

Fig. 8

Screw

Dashboard or Console

Fig. 9