Pioneer Super Tuner IIID AVH-P3100DVD Kurulum Kılavuzu - Sayfa 4
Araç Alıcısı Pioneer Super Tuner IIID AVH-P3100DVD için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer Super Tuner IIID AVH-P3100DVD 8 sayfaları. Dvd rds av receiver
Ayrıca Pioneer Super Tuner IIID AVH-P3100DVD için: Kurulum Kılavuzu (38 sayfalar), Kurulum Kılavuzu (43 sayfalar), Broşür (9 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Installation
Installation with the holder
Note
and side bracket
• Check all connections and systems before final
1. Install the holder into the dashboard.
installation.
After inserting the holder into the dashboard,
• Do not use unauthorized parts. The use of
select and bend the tabs appropriate to the
unauthorized parts may cause malfunctions.
thickness of the dashboard material. (Install
• Consult with your dealer if installation requires
this unit as firmly as possible using the top and
drilling of holes or other modifications of the
bottom tabs. To secure this unit, bend the tabs
vehicle.
90 degrees.)
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result of
Dashboard
a sudden stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons or
(iii) impair the driver's ability to safely operate the
vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit is
Holder
installed at an angle of less than 30°.
2. Install this unit and fasten the screws.
Rubber bush
Double-ended screw
Before installing this unit
Remove the holder.
Dashboard
•
Loosen the screws (3 × 6 mm) to remove the
holder.
Screw (3 × 6 mm)
Holder
Screw (3 × 6 mm)
Installation
3. Attach the trim ring.
2. Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at 3 or 4 locations on each
side.
Trim ring
Installation using the screw
holes on the side of the unit
1. Remove the side brackets.
If the pawl gets in the way,
bend it down.
Side bracket
Factory radio
mounting bracket
Screw for fixing the side
bracket (5 × 6 mm)
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this unit.
Dashboard or console
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.